2014 Mazda 3 Automatic push to start. Using Guide #68451 for remote programming
I successfully installed the EVO-One with T-harness and the car starts with oem remote with no trouble. However, I am attempting to install the RF642W kit with no success. When I plug the antenna into the Evo one it will briefly flash blue but then wont illuminate again under any circumstance. I can put the module in and out of valet mode with 3 presses however if I hold the valet button when the ignition is turned on, I don’t get a horn/chirp like the quick installation guide suggests and thus can’t complete step 2 of the programming process. The evo-one and rf kit are new and have not been paired with other devices. Any help as to where i am going wrong would be appreciated
Evo one sucsessfully installed using guide#68261
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
