Utilisateur

2014 ram 1500 (standard key start) after successful programming, vehicle can be remote started by 3x lock only....H2 - fortin 2 is selected on in flashlink setting, ascl6 app protocol is set to fortin, RFA2A adaptor is connected but still no luck, both red and green led on ascl6 are on solid, been trying to get the evo all to pair with ascl6 with no success.

evo all led lights are stuck at step 8, will not go to step 9 

1 - Disconnect the Black 4 pin power connector from the Evo-All.

2 - Press and Hold the Programming button on the Evo-All while plugging back the Black 4 pin connector.

3 - The LED’s on the Evo-All will begin to cycle. Keep pressing the programming button until the RED and BLUE LED’s are On.

4 - Release the programming button.

5 - Press and Hold the programming button again for 5 seconds. The BLUE and RED LED’s will blink once.

6 - Release the programming button.

7 - Cycle the ignition to the ON position.

8 - The RED, YELLOW and BLUE LED’s will be ON.

9 - Seconds later the RED and BLUE LED’s will blink once to confirm that the MyCar ID has been learned to the Evo-All.

10 - Cycle the vehicle’s ignition to the OFF position to Exit EVO-ALL programming.

EVO-ALL (T-harness) with Linkr LT-2 RF antenna

2009 AUDI A4 with key-port, auto transmission

Step 8 . LEARN THE TELEMATIC DEVICE TO THE EVO-ALL

In order to communicate with the remote starter, the Telematic device must be learned to the EVO-ALL.

1- Disconnect the 4 pin power connector from the Evo-All.

2- Press and Hold the Programming button on the Evo-All while plugging back the Black 4 pin connector.

3- The LED’s on the Evo-All will begin to cycle. Keep pressing the programming button until the RED &

BLUE LED’s are On.

4- Release the programming button.

5- Press & Hold the programming button again for 5 seconds until the BLUE & RED LED’s comes back On.

6- Release the programming button and Cycle the ignition to the ON position.

7- The RED, YELLOW & BLUE LED’s will be ON.

8- At that same moment the RED & BLUE LED’s will blink once to confirm that the MyCar ID has been

learned to the Evo-All.

9- Cycle the vehicle’s ignition to the OFF position to Exit EVO-ALL programming

I can not get red, yellow, blue leds on after cycle ignition on. Only Red and Blue leds are on.

Selected C1, D1, H2 settings for evo-all. Not sure if I need to connect another wire from harness

So the app will not lock,unlock,start,stop.

The Linkr LT app is downloaded on phone, account created, added car. The RF antenna red, green leds are solid/connected to network.

The app antenna icon is green, voltage battery icon is green and shows voltage. Select GPS icon and shows current vehicle location.