Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Carlos Paige

À rejoins en date due:

Oct. 30, 2016

Points

750

Commentaire(s)

27

Questions votée(s)

0

Réponses votée(s)

8

Votes positifs

1

Votes contre

7

Votes reçus

1

Votes négatifs reçus

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

0

I have 3.4v going to brake wire when vehicle is switched on.

Evo One installed on 2005 Avalanche. I have 3.4v at the brake wire when the vehicle is switched to on position. This won't allow the module to start or program rf kit. Is there a resistor I can install on the brake wire to remedy this, or try to locate a different wire to splice into?

0

Evo One not recognizing brake signal or key take over

I have an Evo One starts and stop from FTX64- 2W, tried it in two different vehicles same result. It's not recognizing key take over or 12v to black wire in 20pin connector to shut down. I read in a post, Derek mentioned wiring in a relay from the brakes that would send ground signal to the hood pin wire. Sounds like it will work. Will it have any adverse effect while driving, sending ground signal to the hood pin while driving if the key is not being recognized as being switched on?

0

Cannot get Revo 4.1 kit to program to Evo One.

When trying to program key fobs using guide 88751. I press and hold the valet button, I get a yellow light on top and rapid red led flashing on side below loop. I press the valet 5 times press, press the brake once but no park light flash, and nothing when pressing lock on the fob for 3 to 5 seconds.

0

Evo All and RF-ALL 641W Not starting 06 Dodge Charger.

Installed Evo All with Thar-Chr5 T Harness as a Standalone remote start using guide #28831using F. Flashed to firmware 74.39 using Options- A1-A3, A7-A11, A14, B1, C1, D1, D1.6 ,D1.10, D5, H, H2. Installed RF-All with 641w Fobs using guide 25431. Everything with the fob programming went as stated in the guide. But when trying remote start or any other fob option the fob led work and beep, but I get nothing from the evo all module, like it has no power. Only time the antenna flashed was during fob programming.  

1

Evo One programming key bypass. Does not finish step 4.

I had an Evo One install in my 06 trailblazer. I replaced it, and installed it on an 05 GMC Envoy XL. I did a master reset on starter and bypass, using recommended updates. When trying to program with the button pressed, I plug in the six pin connector to get to the blue led, I then plug in the remaining connectors. Turn the key to the on position the blue light go out but no other lights come on. If I turn the key back to the off position the blue light return. I'm only using all wires from the 6 pin connector. The data, the park light, the horn, the brake, and the A1 ignition wires off the 25 pin connector. And antenna and valet button connection. All wires have continuity though connector and wires. Tried a spare Evo One that had on hand, got the same results.

0

06 Chevy TrailBlazer LS How To Wire Door Unlock And Lock. And Start Issue.

I'm installing an Evo One with the RFkit in an 2006 Chevy Trailblazer. I cant find any information on where to connect the (-) purple lock and unlock wires. And if I need to use relays. Also the unit starts, shut down and immediatly try to restart at a longer cranking time, but never catch and stay running. On Bypass I have options A1-A11 and C1 ON everything else is OFF. On the Starter options 2.1, 1, 4.1, 6.1  and rest Off, 7.1, 8.1, 9.1, 10.1, 11.1  Off 11.4, 12.1, 13.2, 14.1, 15.1, 16.5, 18.1, 19.1, 20.2, 21.1, 24.1, Off 25., 26.1, 29.1, 30.1, 31.1, 32.1, 33.1, 34.1, 35.1, 36.2, 37.1, 38.1 Off, 39.1.

0

Can you buy just the Evo One module without the wire harnesses?

My current unit is not registering the signal from the brake pedal. I have power from brake wire on the car when press going into the Evo One. So I think the circuit in the unit itself is bad. So I only need the Evo One module itself. Unit worked great for 1 year with no problems.

0

05 Hyundai Sonata will not shut off after starting with key fob.

Hi my Evo One was working great for a year. Now when I start my car with either key fob, it will not shut off by pressing the brake with the key out of the key switch. Or by inserting the key and switching to on postion and back to off. The only way to shut it off is with the key fob. Everything else is function normal.

0

EVO ALL With RF ALL 641W

I'm installing an EVO ALL wIth the RF-ALL 641W. It's unusual for this make 2003 Dodge Stratus Sedan. But the car does not have a transponder system, it use standard keys. It has power locks and trunk, but no factory alarm installed. Also when trying to program the key fobs, on Step 4 when I program button, the blue and red light go out then the blue, amber and red lights come back solid and the antenna flashes blue while the key switch is in the off position. Am I missing a component? only need remote start.

0

Site only show T-Harness installation guide. Is there any additional wiring needed for the 05 Hyundai Sonata?

Wiring diagram came with EVO-ONE. But there is no other installation guides on the site other than the T-Harness installation. Does the 05 Hyundai Sonata only require the T-Harness and no other wires connected.

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer