I have a 2006 Dodge ram 2500, automatic trans, diesel motor. I have the following wired up
I have the yellow and yellow wires from pin 20 connected to another yellow wire on t harness.
Have the white/red wire to my starter wire on the truck
Have the white/blue wire to my 12 volt sourc eon the truck.
Have the yellow/red wire cut and using the end closest to the red connector connected to my ignition.
I have the green/red wire connect to my mux wire on the truck.
I have option 15 with diesel selected for 14 min run time.
I follow the programming instructions in the book and the blue led flashes and works like it should.
I press my lock button on the remote three times, the trucks fuel pump, radio turns on. Yet, the truck does not crank, I do not hear the starter making any movement. Everything is working like it should, just the truck does not crank and start/run.
I have tried instructions from 9/20/13 to the latest ones on the website for wiring.
I have also tried firmware-
4.09
4.18
74.07
I reprogrammed the module everytime I changed the firmware and/or wiring with no change. Everything comes on like it is suppose to. Just the truck does not try to crank over or run.
Now if I stick the key in the ignition and crank it over, starts right up. When I press the lock button three times it won't start. I am at a lost at this point.
I did not hook up the hood switch or parking lights, no need to and I do not want them. I follwed the wiring per page 11, letter F. I also followed the programing the remote/module exactly as descirbed and leds flash and do everything they are suppose to. I hit the lock button three times and truck turns the radio, fuel pump, and everything on. Makes no attempt to start the truck or no attempt to crank the truck over at all.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
