User

I have installed an evo-all (s/n # 001AO7065000) in a 2014 toyota camry pts, its work as expected except its will trigger oem alarm either by my or timer. I have turn on the disenable alarm prior to start/enable after shutdown option too but its still trigger alarm, every morning the oem trigger right after remote start shutdown getting very annoying. Also i have installed mycar module with the evo-all, mycar module have an option that will detect the alarm (alarm input detection) and push notifications on the phone but i dont see that the evo-all (harness) have any output to horn that i can tap into for the (alarm input detection) to work. Please advise, thank you so much. This is a repeated question and im apologize for that, because its getting very annoying that the oem alarm trigger at 6 am. Im desperately need help

Hey Guys, i have installed an evo-all and mycar module into an 2014 camry pts. Everythings seem to be in order, only oem alarm trigger after remote start shutdown, please advise. Thank you so much Ps: i found a work around my particular problem, which is unlock the car after remote start although inconvenient and less secure that have to do. Until fortin could some how fix the problem which i have seen many time reading through other questions, if anyone know how to remediate this problem please please share your knowledge. Thank you in advance

S/N 001AO7065000

I have installed a mycar mobile module, its have alarm input detection to notify when alarm trigger. Which wire from evo-all i can use to have that option work, thank you so much

Please reset dcryptor limit for SN# 002504071745

evo 0ne s/n 002b04 291096

Hi, I have and Mazda3 2019 (with push start and presence key) and installed an Evo One + Thar-One-Maz5 + Evo Start2.

I've connected the auxiliary output on a relay to activate the windshield heater and rear window defog (in the mazda3 both are activated together with a ground signal). Its supposed to ground the yellow/black wire when the seat/driving wheel heaters are activated right?

I was not able to test it yet, my car stays in a heated garage and if i understood correctly the evo one uses the internal temperature sensed by the module to activate or not the seat and driving wheel heaters (and the auxiliary signal). So the car doesn't stay parked out for long enough to get so cold inside. 

If i use the defrost button in the app, will it bypass the temperature control and activate the headers/auxiliary signal? If not, is it possible to change config to manually control those? 

Thanks!