Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Josh Ley

Joined on the:

Nov. 29, 2010

Score

500

Comment(s)

11

Voted question(s)

0

Voted answer(s)

0

Votes up

0

Votes down

0

Votes up received

0

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Guide 93711 2019 Toyota Rav4 Hybrid--is option D4 required (hybrid mode)?

Install guide doesn't mention enabling option D4 for Hybrid mode, although the guide is specific for Hybrid. Is this an oversight, or is it not required for this vehicle?

12/03/2020

GMC Josh Ley (500Pts.)

0

Issues With THAR-GM7 in 2016 Sierra 3500 (guide 91291)

THAR-GM7 EVO-ALL and Crimestopper RS4-G5 (datalink; only wires other than Datalink connector from the starter are power and ground because for some reason the starter would not work off the power provided by the DLC) Module programmed fine. Remote start worked several times in a row right after install. Fast forward to next day, delivery of vehicle--remote start worked one time. After that, the ignition would power up but would not attempt to crank. Tried a dozen times, checked plugs. Then the dreaded "service immobilizer system light" came on the dash and I just about S**T a brick. At that point I tried to start with the key--no crank. Wait 30 seconds, thankfully it started up. Reprogrammed module (decryptor process and all) Remote start works fine a dozen or so times, I send the customer on his way. Get a call back within an hour that it's doing all kinds of weird things--locks are acting strange (randomly locking/unlocking) remote start will sometimes work, sometimes not. The weirdest issue is that when he starts with the KEY, drives around, stops, turns the KEY off, the truck will continue running UNTIL the brake is depressed. Could this be a firmware issue? I'm just reviewing the installation manual and it mentions "modules manufactured between certain dates" enable option E5. When I read this during installation I assumed that it was referring to the vehicle manufacture date, not the module. I don't believe the module was manufactured almost a year ago or more, as it came packaged with the THAR-GM7 which just became available.

0

2009 Infiniti FX35 starts, shuts off after a minute or less

Crimestopper RS7-G4 with evo-all, firmware 72.37. has worked fine for several years. Had an issue several months ago that was resolved by updating firmware to 72.36 and reprogramming tach (would start and stall) Now, it’ll start, stay running, and shut down after a minute. Attempt to restart, run for a shorter amount of time, and same on third attempt. I changed firmware to 72.33, 72.34, 72.35, 72.36, 72.37 all with similar results. 72.32 (as recommended in guide 34361) Is this a faulty module? Or is there another possible solution

0

2011 Hyundai Sonata attempt to start 3x, cranks, doesnt catch

Have a 2011 Manual transmission Hyundai Sonata. In the morning, customer states that when remote start is activated, it will attemp to start three times, but it will only crank, and not run. Double checked all wiring.Checked output from remote start, IGN and Start have power while cranking, ACC and ACC2 have power while ON but not cranking. Starter is crimestopper rs4-g5. No bypass module (US model-no transponder key)

27/10/2018

Ram Josh Ley (500Pts.)

0

2015 Ram 1500 Tip Key issues

Have a customer with a 2015 Ram 1500 Tip Key, EVO-ALL standalone install with THAR-CHR6. Its been installed for a few years, no issues. Recently received work at dealership for tailgate lock, and gear selector switch update. At this point, the remote starter would start, and shut down within 5 seconds, and reattempt with the same result. It was running 74.23 firmware. I updated the module to 74.37 firmware; it wouldn't attempt to remote start. I reverted to firmware version 74.29. The vehicle remote starts and stays running. However, (after entering and turning key "ON") when the vehicle is placed into any gear it stalls out within about 5 seconds. This only occurs when the vehicle is remote started and is taken over with the key. Install guide 31951

0

EVO ALL in 2010 Lincoln MKX won't program

I reviewed the other post on this exact issue. At first attempt programming (using programming 3--2 keys) the red led flashed and then blue led flashed. The vehicle wouldn't remote start. I attempted a dozen times changing firmware (4.18, 71.39, 71.35, 71.34, 71.11) and programming using the two key method as well as decryptor process and single key. When attempting to program using the two key method, the red led does not flash, nor does the blue led flash. When using decryptor method, after uploading/downloading and updating the module, the vehicle will not remote start, the security light flashes on the dash indicating no valid key. If I hold the key next to the barrel it will remote start. i swapped out the evo-all for another, same result. I swapped out the evo-all for an evo-ride, the red led does not flash when I press the program buttton. RX (lt blue/blk) is connected to the yellow/org pin 4 of transponder TX (lt blue) is connected to purple/grey pin 3 of transponder connector. I tried swapping RX and TX, module wouldn't go into correct programming mode. I tried using the guide for Ford Edge, connecting evo-all relay output (Wht/blue, wht/red) to +12v, ign. 5 hours troubleshooting this thing. Normally changing firmware solves these type of issues, but I am at a loss.

01/03/2016

Kia Josh Ley (500Pts.)

0

Guide 3056 connection

In guide number 3056 (2014 Kia Sportage push to start) it shows grey and grey/blk from Evo-all as can2 high and low. It shows these wires getting connected to can1 high and low at the back of the fuse panel. Is this the correct wiring connection and just a typo on the diagram? Or do the can2 high/low (grey/blk) go to the obd2 connector wiring? I have a picture of the exact issue in question but the web based form doesn't allow attachments. 

0

Evo-all 2015 RAV4 fail to start first attempt guide 31741

Programmed properly with firmware version 79.31, upgraded to 79.33 with same result. vehicle will attempt to remote start but will only crank on the first attempt. On the subsequent attempt it will start, usually the second attempt, once it took 3 tries. Crimestopper rs4-G5 remote start unit. (-) ground while running connected to remote start output.

0

Evo all rap shutdown bonneville

Still haven't resolved this issue-2002 bonneville evo-all not shutting down RAP system

0

how to reset key override-all Module

First, I programmed this module to be use on my 13 Honda Ridgeline but then decided to use EVO ALL module instead, so I decided to reprogram the KEY-OVERRIDE-ALL module to my other car 2006 Toyota corolla and it did programmed worked good until my battery was disconnected for few days, it kept giving me the hood pin error, I took the module out of the car to try to reprogram it, but when I connected to the computer it is showing the programming from of my truck 2013 Honda ridgeline instead of the programming of the toyota and is not giving me the option to select the car for programming, Do you think that it looked or do I need to reset it to start all over again? Thank you.

0

Brake Bypass for EVO-ONE on '08 GTI w/DSG Automatic

Want to install on an '08 VW GTI with DSG automatic transmission. The problem is that my car requires you to hold the brake to start. No brake = no ignition. This is NOT a push-to-start and I see no regular key diagrams that account for the brake. Is there an output on the EVO-ONE for brake bypass and where does this get spliced into?

0

EVO-ALL not shutting down RAP 2002 Bonneville

Installed INT-SL+, flashed to 3.06, would not program. Flashed to several other versions, still wouldn't program. Removed and installed EVO-ALL, firmware 4.06. first issue: service theft system indicator lights up on the dash when using the remote start. It starts and runs normally when remote started, just the message is displayed in the vehicle information center. second issue, RAP does not shut down after aborted remote start. Guide indicates that this function is compatible with given hardware/firmware.

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue