Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

5 brake flashes anything besides hood?

Have the same 5 brake lights, red light on module both flashing 5 times when trying to start using both 3x lock and car link app, replaced hood pin, re flashed, re programmed module and telescamatics, set to Fortin 2, don’t believe I’ve turned opt 11off but i shouldn’t have to skirting safety devices seems like something an amateur would do, get his necktie caught in the belts while checking the oil and pocket starts the vehicle…..whatever, new system self installed worked until it didn’t, any ideas? Would be very appreciated!

0

prius 2010

Prius 2010 de base push to start avec un evo one le vehicule flash 5 fois et et ne demarre pas

0

2013 Toyota Corolla Evo-All stuck on step 5 in programming procedure

Hi, I installed a remote start on a 2013 Toyota Corolla that uses the Evo-All bypass module. I am currently stuck on step 5 of the programming procedure on page 3. When I turn the key to the on position the blue and red led light from the previous step turn off and nothing happens. I checked all the wiring going to the ODBll with a multimeter and everything seems fine. The remote start does crank over the engine but will not start unless the key is close to the ignition. Does anybody have any suggestions?

0

Truck remote starts, but horn goes off like the alarm is set off

Got my unit to start the truck, but the alarm seems like it is going off while it's running. Can't figure out why.

0

EVOALL-GM5 STEP 5 PROBLEM

2016 1/2 Silverado w/EVO-ALL w/THAR-GM5 Stand Alone: At step 5 (page 7 install) instead getting RED and YELLOW LED's flashing when ignition is turned on....?

0

2011 chevy cruze step 5 will not change from yellow to red just stays yellow

2011 Chevrolet Cruze, standard switchblade key with ignition cylinder on column (not push to start). Using EVO-GMT1, with the t-harness. Only wire I have wired to the vehicle for now is the brown wire on the 5 pin connector, and that is spliced into the number 1 pin at the dlc for can bus. I can get programming to step 5. I have hit the program button 5 times, and it will flash 5 times in 4 sequences, and then stay on yellow when its done. When i turn the key it stays yellow and nothing happens. I do not want any other feature this offers, except 3 lock remote start. I have verified switching 0-3v at the brown terminal with key on, and have wired it multiple ways to verify it's not something I did. I was able to get it to turn red once, turned the key off, removed the key, waited 5 seconds, and turned the key back on and it stayed red. I am a gm technician and very familiar with these vehicles but I can not get this thing to program.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue