English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

jeff panotes

À rejoins en date due:

Feb. 9, 2018

Points

590

Commentaire(s)

8

Questions votée(s)

0

Réponses votée(s)

1

Votes positifs

0

Votes contre

1

Votes reçus

3

Votes négatifs reçus

0

Activité récente

Questions demandée(s)

13

Question(s) répondue(s)

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question
ACTIVITÉ RÉCENTE QUESTION(S) DEMANDÉE(S)" QUESTION(S) RÉPONDU(S)" QUESTION(S) COMMENTÉE(S)"

22/07/2018

 Kia jeff panotes (590Pts.)

3

Flash limit exceeded

Was having issues with the unit was told to reprogram unit thought I would do a fresh install on the Flash when trying to re Flash it says Flash limit exceeded so I stopped in didn't do anything Thought unit was not learning correctly so was told to re program and re Flash that's when I got that Flash exceeded limit warning Also planning on adding drone mobile but I will have to re Flash if I've already exceeded the limit how can this be If I still need to re Flash to the drone mobile Can I just start over and erase all the flashes on there or do I have to call customer service and have them do it
Connectez-vous pour répondre Voir 2 réponse(s)

22/07/2018

 Kia jeff panotes (590Pts.)

0

Drone mobile dr5400 compatible with evo one

Is the dr3100 drome mobile the same as the dr5400 only with lte service
Connectez-vous pour répondre Voir 1 réponse(s)

09/07/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul singal or double pulse for locks

Do i need a single or double pulse for the locks to work correctly .I had it set on single pulse .25 sec but locks dont seem to unlock all the time . except driver side. Already reprogramed the unit again followed programming for no ems wire or becuse this is hooked up to the can bus should i use the other programing methed .
Connectez-vous pour répondre Voir 1 réponse(s)

04/07/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul canbus

On the evo one remote start is hooked up through can bus but seems to have a hard time with lock and unlock function . My question is if I have the can bus hooked up can I also hard wire the triggers in or is it one or the other when being installed
Connectez-vous pour répondre Voir 1 réponse(s)

27/03/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul standerd key oem key fob no control once remote started.

with the evo one in remote start the oem key fob has no control over the door locks or the arm or disarm of the evo one. in the settengs i have the oem remote settings enabled on both the remote start and alarm side or is there something that I am missing.or not set correctlly.
Connectez-vous pour répondre Voir 1 réponse(s)

06/03/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul want to add shock sensor and glass break sensor are they compatibale with evo one

looking to add the glass and shock sensors to evo one to get the alarm functionality out of the device,I know a shock sensor is doable have seen it on videos online. but what about a glass break sensor . I was looking at the dei 504d and the dei 506t. The 506t has a double harness that would connect into the shock sensor and then go into the evo one unit . What would be the pin out to make it work and or what options would i have to enable either on the bypass side or the remote start/alarm side to make that work.
Connectez-vous pour répondre Voir 1 réponse(s)

06/03/2018

 FAQ jeff panotes (590Pts.)

0

Fortin flu saving or not saving settings

When saving on the Fortin Flu a red circle with an exclamation point shows and settings saved pops up .Does this mean that the settings are not correct for my application or is something wrong that may be im not doing. I know a few time that i have saved stuff on the FLU there was a regular looking settings saved pop up nothing with an exclamation point or any thing .. Wnt to make sure i am saving correctly so i wont have any issues. Please advise.
Connectez-vous pour répondre Voir 1 réponse(s)

06/03/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul evo one alarm options settings not saving when taping save .

I was going through the alarm settings on the evo one and when i hit save it dosent seem to save it .The setting im talking about is option 24 i click on disable hit save and it goes back to 24.3.. tried it a few times keeps doing it.Im also trying to enable option 37.2 also saved to device . Unplugged device reinstalled tested it out. Are these 2 options related in some way or is there something on the bypass side that needs to be done .. on the remote start / alarm side of the evo what options would work well together or is it some option you cant have on or actived at the same time. Basically what i was tring to do is this . If the door was open by key fob car would stay running.By option 37.2 enabled. if someone opened the door by inside handle car would shut down . I have changed setting back and fourth a few times and not to sure what options should be on or off at this point any help is greatly appreiated
Connectez-vous pour répondre Voir 1 réponse(s)

26/02/2018

 Kia jeff panotes (590Pts.)

0

General question about evo one . Horn out put is a neg trigger. I have a siren that has a pos and neg wires .

The evo one has a neg output for siren or horn no relay is needed the question is the siren has a neg wire to chassis ground and pos wire to 12 volt . Can it be wired up like this. Siren pos to 12 volt and neg chassis ground to neg trigger on the evo one . Is this possible or will that wiring burn up the evo one. Or should i use a relay to change the ouput to a pos trigger and power it through a relay with the evo one neg trigger
Connectez-vous pour répondre Voir 2 réponse(s)

26/02/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul standard key evo one unlock does not unlock trunk at all times

All locks work priority unlock drivers side double tap unlocks all doors except trunk it seems it has a hard time is this a settings issue program issue
Connectez-vous pour répondre Voir 1 réponse(s)

25/02/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul standard key aux wire placement for rear defrost and programing options.

Looking for wire placement for the aux function for the rear defrost. wire color says White Dash fuse box, plug (E) pin 16 . But no picture on wire color .To verify i have the right connector .Could i just tap into the switch itself or is it at this pin because its after a relay.The aux wire on the evo one is a neg output does that mean it has to go on the neg side of the wire or does this need a relay to change output to correct trigger. Also what programming setting would be the best to use. Testing rear defrost to see if latched or pulsed is itbest to check at switch or from the rear defroster itself.
Connectez-vous pour répondre Voir 1 réponse(s)

17/02/2018

 Kia jeff panotes (590Pts.)

0

2016 kia soul standerd key/ wire outputs for evo one with T harness needs some clarification

The wording to me seems diffarant than what im use to just need some clarification. 2016 kia soul standard key evo one with t harness rf kit 642w -2way 1. neg ignition green output 750 ma . This is basically saying if i need a seconed ignition wire this going to be used in conjuction with a relay to achieve that seconed ignition wire? 2.neg start white output 750ma . same thing as above if i need a seconed starter wire this is going to be used with a relay to achive that? 3. neg disarm orange output 750ma . this is to shut down factory alarm connected to factory disarm wire normally when you un lock the dooor with the key,wire is normally found in kick panel. 4. pos foot brake black input . normally attached to foot brake to shut down remote start? That was my understanding of these wires please correct me if wrong. Does all the fortin evo all have 750ma outputs and do the require relays to use? Again maybe im reading and understanding these wrong.
Connectez-vous pour répondre Voir 2 réponse(s)

16/02/2018

 Kia jeff panotes (590Pts.)

0

Evo one siren relay needed or only for a factory horn a relay is needed

Does the evo one require a relay for a siren output or does this unit has a on board relay for that option.Or just like a factory horn hook up you need a external relay becuase it is to much power being drawn on the circuit.
Connectez-vous pour répondre Voir 1 réponse(s)

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer