Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2017 Golf Alltrack PTS no start

2017 VW Golf Alltrack PTS A/T Installed EVO-VWT1 with r-link stand alone, programed unit to lock-unlock-lock and vehicle started without any problems 4 times. Decided to change the setting to 3x lock start and and turned on reset protection for EVO-ALL, but after pluging evo back vehicle does not start, no blue,yellow or red led flashing when i lock or unlock the doors. Unit recieves power as i tested with programing step one (hold button while pluging 4pin) and all leds alternate. Decided to ask if anyone had same issue before i try master reset.

0

2016 VW Golf Sportwagen Inconsistent starting especially with EVO-START

I Have recently installed an EVO-ALL with EVO-START into a 2016 VW Golf Sportwagen. Regular Key-start.

With factory settings A1-A11, D1, D2(factory alarm) C1 & H2(evo-start) all turned ON. The car seems to start at random with this setup it will work sometimes and then will not start on an immobilizer error. Once I get the error it will not remote start again.. but then if I manually cycle the key on/off in the ignition, get out of the car and remote start it will usually work again. 

If I wrap the key in series from the evo-all to the transponder (D4 white/green wire from evo-all module directly to key wrap and then out of key wrap to transpoder wire) and then turn OFF option A3 the car remote starts perfectly every time. but will also start manually with a NON-CHIP key. (always sending transponder key)


The key wrap has been checked and redone (just to make sure) as has all the wiring and everything is good. Firmware version is up to date as recommended. I even tried another evo all module to make sure and got the same result.


I'm really not sure what else to check at this point,  But with A3 on and white/green wired in parallel with the wrap/transponder I get very random starting results will work several times in a row and then not start on an imoblizer error the evo-start is less consistant than than 3x lock on the oem remote but both are not near consistant enough. 

 

 

Is it possible to wire this set up with a transponder ring/wrap instead of the cut transpnder wire on the car? Not sure if that would help provide more consistant results?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer