English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

27/02/2024

 Subaru Joshua Swenson (1660Pts.)

0

2020 Subaru Forester install questions

1. In this thread from a while ago, it was said that enabling 3x lock is not recommended for a 2019. Does this still apply? https://fortin.ca/en/qa/90775/LockLockLock-Forester-Sport-2019/ EDIT: May have been fixed in firmware 1.24 AKA 0.60? 2. Guide 98941, page 7. I'm probably over analyzing this, but I assume for the Yellow/Red and Yellow/Green wires, the illustration is saying to connect the respective wires together. Is that correct? I figured there would be a black circle on it if that was a case. I initially thought this was a spliced wire from the factory. 3. Will there be issues if I use an Omega RF kit and have to use firmware 0.44? Thanks all!
Connectez-vous pour répondre Voir 1 réponse(s)

24/04/2020

 Subaru Brandon Chew (210Pts.)

0

T-Harnes for 2014 Subaru Push to Start

Is there any T Harness that suits 2014 Subaru push to start? Every other make and model seems to be using them and it's a much easier install.
Connectez-vous pour répondre Voir 1 réponse(s)

20/10/2019

 Subaru serge robillard (130Pts.)

0

LockLockLock Forester Sport 2019

When an update will be availbale to have the LockLockLock option for
Forester Sport 2019 (Push to Start)

My system is installed since close a year and still waiting for this function.

Thanks

Connectez-vous pour répondre Voir 1 réponse(s)

22/10/2018

 Subaru Mark Serfass (130Pts.)

0

2012 Subaru Forester Manual Trans. Evo-One OEM key fob

2012 Subaru Forester Manual Trans. Evo-One OEM key fob.
setup according to #54711 guide, except hood pin is not used.
Flashed to 79.49 & 1.24 ran the decrypter, then set the standard settings in both tabs. 83.2 C1 & D5 enabled
When I press the lock 3x times the horn beeps, the parking lights flash 3 times the radio & Dash lights flash. but it does not start. In reading the help guide, it says the EVO-One red light should turn on, it does not.
Any help would be much appreciated. 

Connectez-vous pour répondre Voir 1 réponse(s)

27/09/2018

 Subaru Gaetan Roussel (260Pts.)

0

Which Start wire to use on Forester 2009 ?

I recently acquired a 2009 Forester. Using a Fortin Evo-All and a Crime Stopper RS2-G3 remote starter I cannot figure out which Start wire to use. 1) Your installation guide suggest the use of Start wires Ter 1 (White/Black) and 2 (White/Red) while the RS2-G3 connector only has one Start wire (Brown). How should I make the proper connection(s) ? 2) As well, the remote starter has two (2) Constant 12V (+) Input Red wires on its 6 pin power harness. Should both of them be connected to the RS2 (+) 12V white wire of the Forester Ignition harness ? PS. I see that on the Evo One installation you use a relay on the Start Ter 2 wire.
Connectez-vous pour répondre Voir 1 réponse(s)

27/09/2018

 Subaru Gaetan Roussel (260Pts.)

0

Which Start wire to use on Forester 2009 ?

I recently acquired a 2009 Forester. Using a Fortin Evo-All and a Crime Stopper RS2-G3 remote starter I cannot figure out which Start wire to use. 1) Your installation guide suggest the use of Start wires Ter 1 (White/Black) and 2 (White/Red) while the RS2-G3 connector only has one Start wire (Brown). How should I make the proper connection(s) ? 2) As well, the remote starter has two (2) Constant 12V (+) Input Red wires on its 6 pin power harness. Should both of them be connected to the RS2 (+) 12V white wire of the Forester Ignition harness ? PS. I see that on the Evo One installation you use a relay on the Start Ter 2 wire.
Connectez-vous pour répondre Voir 1 réponse(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Connectez-vous pour répondre Voir 3 réponse(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Connectez-vous pour répondre Voir 3 réponse(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Connectez-vous pour répondre Voir 3 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer