Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2013 Chevrolet 2500 HD -Starts once then won’t crank

I have installed Evo All SN 001A07 468692 with T-Harness THAR-GM4 withRM942 remotes and MYCAR using hrn-11rs-01. The factory remotes work as well as the 942. The truck will start once using the remote start and then just light up and “click”. If I unplug the module it will work again. From reading through the messages here I believe the issue is that I have flashed it too many times. Any help would be great

0

3x remote flash won't start

2004 Chevrolet Suburban 1500, I've been having issues for 3 months now. I replaced brake switch twice, wire harness for brake switch, and still the same issue. If I unplug the brake wire from EVO-ONE, it would remote start. If the wire is plugged in, no start. This started after 3 years of module use, nothing changed. Now, EVO-ONE is doing a 3X light blink when trying to remote start, which is ready mode disabled. It's an automatic transmission, it's in Park, no parking brake on, still nothing. Last week I was able to bypass the brake switch with a separate switch to solve the other remote start issue, but 2 days later it's doing the ready mode disabled. I'm about to give up, rip this thing out and try a different brand.

0

3x remote flash won't start

2004 Chevrolet Suburban 1500, I've been having issues for 3 months now. I replaced brake switch twice, wire harness for brake switch, and still the same issue. If I unplug the brake wire from EVO-ONE, it would remote start. If the wire is plugged in, no start. This started after 3 years of module use, nothing changed. Now, EVO-ONE is doing a 3X light blink when trying to remote start, which is ready mode disabled. It's an automatic transmission, it's in Park, no parking brake on, still nothing. Last week I was able to bypass the brake switch with a separate switch to solve the other remote start issue, but 2 days later it's doing the ready mode disabled. I'm about to give up, rip this thing out and try a different brand.

0

EVO-ONE after 1,5 years stopped

After just over a year and half, and just less than a week ago it was working fine, my remote start no longer works. It acts like the vehicle battery is dead. I have checked the module, red led comes on, then yellow, then everything off like dead battery. If I pop the hood, it says not ready. Door open, not ready. So it tries but fails. Vehicle battery is fine, and vehicle starts fine with the key. Do I need to reflash the module? Defective module? Vehicle battery to low? 2004 Chevy Suburban 2LT Standard Key. Lock, unlock, panic all work. I also have RFK4411 remotes. Same issue no matter which remote is used. This is a video: https://youtu.be/_jvPEv49Gbo?si=5QQzIXTqbi71WNgC

0

2015 Silverado work truck with no fobs. Can i add a remote start with fortin remotes?

0

2015 Silverado work truck with no fobs. Can i add a remote start with fortin remotes?

0

Problem with programming key bypass

When programming for the key bypass on evo all cannot get it the flashing blue light when turn the key to on position I've reset and have had the module reset by you guys and am flashing correctly for 2011 chevy silverado what can I do to get the key bypass step programed?also I have the evo all with thargm4 harness with oem remote start fob and have flash link 4

0

Headlights

EVO 441 2020 Chevy Express 2500.(Headlights in Auto)After Remote start -key inserted -turn to run -Headlights cycle off and back on (Display Says Auto lights off -Auto lights on). EVO flashing rapid Amber until Van is shut off and a restart has occurred Wired to Guide #59141 Revision 20230316. EVO Brown /White to Lt Blue BCM passenger White 25 pin plug pin 8 I think the Lt Blue can be captured at the back of the Headlight switch Would this be a better option or have the same result? I don’t have access to a wiring diagram and I do not want to try something that will lead to a bigger issue Everything else works as intended The instructions are great as is the product I would recommend to anyone wanting a aftermarket remote start

0

I have 2020 chevrolet silverado 3500 super duty an ned all in one module and harness so which one is work for my truck?

I have 2020 chevrolet silverado 3500 super duty an ned all in one module and

0

Do you make a remote start kit for 1993 Chevy s10 blazer

I bought the Bluetooth Flash . I want to do installs . Id like to start with my own . It’s a 1993 chevy s10 blazer non power interior. What products do I need for installation

0

Evo One LTE will not remote start, unlock and lock doors from phone.

Hello, I recently installed the Evo One LTE USA. The oem remote works fine to remote start the vehicle but anything to do with the evo start module won't work. It shows the doors being unlocked and opened, battery voltage, and temperature. I configured the RF kit as the Evo Start 2 when flashing my Evo One, could that be the issue? I also could not find a wiring diagram anywhere on either of your websites which would probably help me. I could only find the wiring diagram for the canadian version with the antenna. Vehicle is a 2015 Chevrolet Silverado 1500. Using Gm7 T-harness.

0

I use evo all GM 6 MALIBU 2020

I use evo all GM 6 In MALIBU 2020 Car start and shut off but display not off battry lose power everyday If I start the vehicle and it shut off automatically display not off

0

I use evo all GM 6 MALIBU 2020

I use evo all GM 6 In MALIBU 2020 Car start and shut off but display not off battry lose power everyday If I start the vehicle and it shut off automatically display not off

0

2023 Chevy Blazer

Do you have any solutions available for the 2023 Chevy Blazer? Was there a change in can data from the 2022 model?

0

EVO-ONE after 1,5 years stopped

After just over a year and half, and just less than a week ago it was working fine, my remote start no longer works. It acts like the vehicle battery is dead. I have checked the module, red led comes on, then yellow, then everything off like dead battery. If I pop the hood, it says not ready. Door open, not ready. So it tries but fails. Vehicle battery is fine, and vehicle starts fine with the key. Do I need to reflash the module? Defective module? Vehicle battery to low? 2004 Chevy Suburban 2LT Standard Key. Lock, unlock, panic all work. I also have RFK4411 remotes. Same issue no matter which remote is used. This is a video: https://youtu.be/_jvPEv49Gbo?si=5QQzIXTqbi71WNgC

0

wont send dagta to module after programming

everything goes good up until i connect to flashllink manager then it says incomplete immobilizer data

0

Why Does OEM Alarm Go-Off Almost Every Time I AutoStart ?

2014 Chevrolet Cruze Normal Key Automatic SN: 001A07 468661 It doesn't do it all the time and despite the alarm going-off it does start the car and everything else (door lock/unlock) works too EVO-ALL. Used T-Harness for install. I'm sure I'm not doing a step correctly or sometimes I might be locking the car with the OEM fob when maybe I need to be always using the Fortin fob (one-button type, forget the name of it) =] Any ideas?

0

Cant figure out how to program my 2014 camaro

Evo all SN:001A07 254011 I have tried so many programming instructions but nothing works. I ether get a solid blue light when i need a blinking blue light or I get a solid red and yellow when I need a 10 blinking yellow.

0

Unable to reset start-x module

Performed reset procedures, did not work

0

'18 Malibu Flashing Headlights & DRLs

Hello, I have an '18 Malibu smart key and I have installed the EVO-ALL module and programmed. While the car is starting via the module, it seems it is glitchy. The dash turns on and off, displaying different messages, and the headlights and daytime running lights will turn on and off as well. This ends with the headlights off, DRLs on, and brake lights on. My question is if this is normal? And if so, I would suggest an update to the module. One time I remote started the car and after a second, the dash displayed No Remote Detected, then everything turned off and then the car started after a few more seconds. I noticed the harness has a couple loose wires and a couple other connectors attached. Do these need to be connected to anything?

0

Can I use a RF kit connected to my evo all to control my crimestopper remote start?

I have the remote start working but my wife washed the 2 way remote. A new one is more expensive than an upgraded RF kit. Can I plug the rf kit into the evo all to control the start and door lock functions of the Crimestopper or plug the rf kit directly into the crimestopper?

0

2012 Chevy Captiva, What is needed for remote start

I have a 2012 Chevy Captiva and would like to add remote start. What all is needed to complete the job. I would like to use the vehicles's remote key FOB if possible.

0

Wiring EVO-ALL 2006-Chevy-Trailblazer

I am installing a EVO-ALL on a 2006 Trailbalzer LS. The diagram only shows 4 wire connections. I want to trigger using the factory remotes. Am I missing somehting. It shows Connection 3 with Program 3.

0

2016 Chevrolet Malibu standard key Evo One

Hi guys. Do you know if there is any solution for the 2016 chevy malibu limited flip standard key? It happens that all the connectors match the 2015 connections but the colors do not. I would like to install an Evo one with RF kit. I've been looking on the website but I don't see anything for this car specifically. Any recommendation? Thanks.

0

Evo All w/Xl202 - Do we need to enable option b2 and swap rx/tx?

2019 Chevy Express - Evo All w/ directed XL202 as the RF kit - Using the Evo ALL as alarm and RS with an existing viper FOB (and OEM remote as a backup) I noticed an option b2 in flashlink that vague and mentions changing the input/output of the antenna for different RF kits Does this mean we can enable this and NOT need to swap the white and blue on the data cable? Or do we leave that option alone and swap the wires? Or both? Trying to avoid figuring this out with trial and error before my install in a couple days.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer