Hello,
I have a 2018 Chevy Cruze (push to start) w/ Manual transmission - Evo One and TharGM6 T-Harness
***The recommended setting are applied and I have place the required 180 ohm resistor from the clutch sensor to A5(white wire) on the main connection and all firmwares have been updated(flasher, bypass, starter)
When I follow the instructions to put the remote start into ready mode the following happens:
When I release the brake pedal, the car unlocks and the red and amber leds light up on the Evo
As soon as I open the door the vehicle shuts down
After I close the door and wait, I then attempt to start it and I get the three flashing parking lights indicating it is not in ready mode. I can lock/unlock the doors as well as the trunk, but I cannot start the vehicle. Please help.