Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Bob Z.

Joined on the:

Dec. 26, 2016

Score

160

Comment(s)

2

Voted question(s)

0

Voted answer(s)

0

Votes up

0

Votes down

0

Votes up received

0

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Is my Module Faulty

Installed EVO ONE on a 2001 Chevrolet Suburban with NO T-harness. Plugged module per procedure, Blue light came on, Plugged in harnesses, released button, no red light came on. Tried several times, troubleshooting says J1850 serial data line not seen. Tested line with scan tool and functioning fine. Checked continuity from OBD connector to module connector - good. Confirmed conection from connector to module pin - good. Looking for input if module is faulty. Please advise. Regards, Bob____

03/01/2019

GMC Bob Z. (160Pts.)

0

Check engine light on with codes when using remote start

Hello, installed evo-one in my wife's 2005 Yukon. directions very good with the exception of step three when hooking up E1 (+)Ignition2 - White wire & E2 (+)Accessory - Orange wire.

Identified six-pin connector to the left of the steering column. Cavities & wire guage do not correspond. Contacted associate at Chevrolet dealer, looked up schematic and confirmed/identified th following;

Cavity "A" is "Ignition 3 Voltage" - orange wire

Cavity "B" is "Right Turn Signal Switch signal" - Light Green wire

Cavity "C" is "Left Turn Signal Switch signal" - Dark Green wire

Cavity "D" is "Hazard Switch signal" - White wire

Cavity "E" is "Off/Run/Crank Voltage" - yellow wire

Cavity "F" is " Accessory Voltage" ​- Brown wire 

Connected E1 (+)Ignition2 - White wire to Cavity "E" - "Off/Run/Crank Voltage" 

Connected E2 (+)Accessory - Orange wire to Cavity "F" is "AccessoryVoltage" ​- Brown.

Vehicle starts and dies with the remote start and sets several body codes.

Changed connection of E1 (+)Ignition2 - White wire to Cavity "A" - "Ignition 3 Voltage" - orange wire. Every thing seems to work but still getting check engine light with remote start - up to eight codes, 

Open Torque Converter clutch circuit

Shift timing solenoid

Open Torque Converter clutch pressure control solenoid circuit

O2 sensor heater circuit open

Seems I may need to jumper a voltage feed to Cavity "E" - "Off/Run/Crank Voltage"  for remote starting operation? Please advise

Regards, Bob

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue