User

2012 Audi S4 with Push button start, automatic trans, Installed EVO-ALL+THAR AUD1. (latest firmware confirmed with flashlink)

If the canbus is alive, the car will start on 3x lock of oem fob.

If the car is asleep, as in it sits overnight then "4x" lock is required to start the engine.

Something I've also noticed is 3x lock does not stop the engine when it has been started by the EVO-ALL module..so if engine is started with fortin module, no amount of fob lock button pressed will not stop the engine.

The system was updated with flashlink during the install process and only setting changed was the start run time length from 5mins to 30mins.

All the wiring that is required with the THAR-AUD1 has ben double checked and as mentioend, if canbus is live it'll start perfectly fine on 3x lock, it's just when the vehcle is asleep it's like you need to press the remote 1x to wake up the canbus and then 3x to start the engine. 

The 3x lock to shut off engine after start with fortin system, I'm not sure if this is possible or correct so I'm not 100% this is a concern.

Is any of the above normal operation?

2012 Audi S4

I just programmed 2 new remotes to Nano Start V3, old remotes lost and unknown if system was working previously.

New remotes confirmed programmed and will LOCK / UNLOCK / TRUNK.

LED on antenna is flashing.

When pressing "START", the door locks cycle and dome light comes ON pause  door locks cycle again. pause alarm chirps and hazards flash then doors cycle again. pause door locks cycle again. pause alarm chirps and dome light goes out. pause

LED on antenna is flashing whole time for operation and continues to flash after, also good to mention the OEM Audi fob is more than 10meters away from vehicle..

I'm not sure if I messed something up programming the key fob but seemed simple enough - Key ON/ hold button till LED flashes and release / press button once / press brake / press LOCK button on 2 new fobs / press brake / key OFF. Tested both remotes and confirm programmed..

What am I missing?

2012 Audi S4 push button start DSG.

Lost the remote fob and need to replace (lost in transit when railing car from montreal to outwest). Car is from Montreal but recently moved to British Columbia, closest distributer is 5 hours away.

I accessed the module under dash, it's a Nano Start, Hardware V3. Firmware V10.17.

I have the installation manual to program the unit not sure of which remote and where to buy online,

What's the model# for the fob replacement? Is there a place to order the remote fob online?

(Also can this nano start have something added to use the oem key to 3x-lock-start?)