2017 Forester with Standard key
Wired with guide #57211 and used T-harness
flash link updater updated to current V:4.03
Evo one updated to 79.45 for the 2107 forester
evo one promgrammed in car and went good
I did not wire up the Power lift gate wire and the Hood pin wire
In the bypass mode I have A1-A9 selected ON, (A10, A11,B1 selected OFF), C1,D2 selected ON, (D3-D6 selected OFF)
In remote starter mode V:1.24 updated and only ones i changed were 6.2 selected and 38.2 selected
then did Dcryptor programming and it went fine
put the evo one back in the car and no remote start
all standard key features are working
i shut the door and can see the evo one and when i lock or unlock there are no lights coming on, on the evo one. isn't the blue light?
i thought it was IMO wires so i disconnected the red connector and tried to start the car and it will start but will shut off after a few seconds
when i pull the red connector back in and start the car, the red light on the evo one lights up soild
Service Number: 002B07 237674
Please Help!!!
I also tried the older firmware verison of the remote start mode and still NOTHING
Also I was driving home last night and my passenger door switches are not illuminating.
What is going on????
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
