hello, i am intalling evo-one remote start on my 2017 ford transit, i am using a t-harness " thar-ford1 rev.1 lot:50467" big 6/7 pin connecter fits right on the lock, but small 4 pin connecter for pod signal has no where to plug in, there is no other 4 pin connecter in streeting colum/ lock area. i used instaletion guide #31771 rev:20170303 which shows that small 4 pin connector should plug in on the bottom of the lock, but my vehicle doesnt have that connecter. How can i maka this work?
Or even if i use the regualar instalation guide "31771 rev:20171206 i need to find these two wires rx which is purple/grey and tx which is yellow/orange they should connect to a10 and a20 on the evo one. but my car doesnt have those wire colors. or the 4 pin connecter anywhere near the lock.
if so could i use the t-harness without the 4 pin connecter and just splice the two pod signals rx and tx, if i will find the wire colors for them.
help would be appreciated thank you.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
