Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

25/12/2022

 Volkswagen chris tuulos (160Pts.)

0

Evo Start 2 says running for a few seconds then says off but car is running

Installed Evo all with twvw1 harness and Evo start 2 yellow wire from Evo start 2 connected to purple/yelllow wire from Evo All (ign + out) Evo start will say "Engine On" but the tach needle doesn't change, and then it says that the engine is off the next status request I send. But the car is running. It will show that the voltage is 14+ and the temp rising in the car. But shows the engine off.
Login to reply View 1 answer(s)

28/11/2021

 Volkswagen Jerry Martin2 (310Pts.)

0

evostart 2 not starting with app

hi, installed a evo one with a evostart2 car start with 3x lock. installed evostart with rfa2a ignition wire ok have power on red wire and ground on black programmed evostart several time but still doesnt work made master reset and reprogrammed still same problem. perform validation step on page 15 of the guide ignition came on and door unlocked and ignition turned off. retried still no start with app.car start with 3x lock.im in the red coverage zone and my personal car which has evostart works fine.so coverage shouldnt be an issue except if its not the same between evostart and evostart2. evostart demand firmware 1.21 minimum i have 1.25 could it be the cause or maybe something else im pretty much lost at this time since every time i programmed i got the flashing blue then the green led. like it should tried programming with the switch and the brake pedal which seemed to have work but no luck.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue