Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Is Fortin planning on releasing a T-harness and install procedure for a 2025 Mazda CX-50?

I had a 2025 CX-50 in the garage a few weeks back, pulled the install procedure available for the CX-50 which seemed valid for 23-24 model years. I confirmed the BCM connectors on the 2025 do not match the 23-24 so I'm assuming Mazda made changes. Is there a plan to release a T-Harness and install procedure for a 2025 Mazda CX-50 in the near future? My preference would be to use the EVO-ONE with T-Harness and an RF Kit.

13/07/2025

Mazda Riya P (330Pts.)

0

My Evo One will not flash during the flash link process

My Evo one is not flashing (doesnt even say I reached my flash limit, it just refuses to flash) when I choose my setting and my car specifics during the flashlink manager process (before decryption ofc). Not too sure if it needs another reset, as the last one I asked for didnt fully reset, my car settings were still shown. Any help is appreciated at this point, thank you. SN: 002B04 267246.

27/12/2023

Mazda Mmk005 (130Pts.)

0

Evo Start 2 not working with Evo one with T Harness Thar one Maz3

Hello,

I recently bought Evo start 2 for my Evo one which I have been using for more than 2 years on my Mazda cx 3 2019 with T harness. At that time I did not choose the app start option while programming the Evo one. Can some please help me where should i be connecting the Yellow wire. Does it goes into the A1. Also none of the other options like door unlock are not working. Do I have to reprogram the Evo one again. I know that the firmware should be atleast 1.21. When i push start from the app the green light on the evo start 2 is turning on but nothing is happening.

I have followed the following steps and it was not working.

Ignition ON - OFF - ON (While holding the brake?)

Press and release brake 4 times

Press and hold the Evo start button until green

Turn OFF Ignition

Thank you for reading any kind of help or suggestions is much appreciated 

0

can you program fortin-all with one remote key?

i have a 2018 cx-9 and i only have one remote/key. in the instructions, it says i need two. Is there a way to use only one key?

1

Can anyone confirm Dcryptor servers are functional at the moment?

Dcryptor has been getting stuck at 'processing update' on multiple attempts since yesterday for me. The EVO-ONE responds with the correct LED sequences when configured in the car before decryption. I have also tried multiple computers and uninstalling/reinstalling the program. This is for an EVO-ONE + THAR-ONE-MAZ3 in a 2018 Mazda CX-5.

1

Can anyone confirm Dcryptor servers are functional at the moment?

Dcryptor has been getting stuck at 'processing update' on multiple attempts since yesterday for me. The EVO-ONE responds with the correct LED sequences when configured in the car before decryption. I have also tried multiple computers and uninstalling/reinstalling the program. This is for an EVO-ONE + THAR-ONE-MAZ3 in a 2018 Mazda CX-5.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue