Ford 2019 Question & Answers

Looking to get Mycar module. I have a 2019 explorer with evo all standalone fort3 harness. I set it up using lock/unlock/lock to remote start. Mycar directions is showing 3x lock for install. Will it work using my configuration? If I have to, I will disable horn honk with lock press with forscan, but I would rather not if possible.

evo-all

2019

mycar

stand-alone

15/01/2021

Ford Bradley Hartman (330Pts.)

EVO ALL won't recognize keys on 2019 Ford Explorer during programming

Evo all standalone wire to wire with t-harness firmware 71.52(i have also tried 71.49, 4.01, 7.47, and programming related to listed firmwares) I am trying to do 2 key programming. When I get to the step of holding(the folded key) to the ignition, press the button on EVO, nothing happens. Nothing progresses. Any ideas for where I need to look? CAN bus is wired and voltage tested good. Wires were stripped, wrapped, and taped. Module does seem to communicate with vehicle with key fob sending lock/unlock(blue LED lights up) functions, then doing the lock/unlock/lock, it flashes 5 times RED which i know means hood open. Not sure why as the toggle switch has a good ground and is turned off. The toggle is wired into the dark blue A8 wire on the 20 pin connector. Please advise

07/01/2020

Ford Nolan Haugen (130Pts.)

park lights 2019 f250

on the 2019 f250 it says to interupt pin 4 (ground) with the yellow and red and yellow and green wires from evo all and to splice into pin 11 (park light) circuit. after doing this during programming it seemed to blow ign fuse 18 5a. part 2 of this question. the remote start is a pro start (supplied by customer) and we are using the ford t harness is the pro start a data link or direct link compatible remote start or does the evo all need to be hard wired ?

t-harness

remote-start

2019

25/12/2019

Ford Derek Weber (250Pts.)

Which Ford firmware for 1 Key programming?

2019 Ford F450 Diesel: EVO-FORT3, 1 Key programming: Manual indicates Firmware version 4.01 "only" but after flashing for 4.01 it states "recommended firmware is not loaded" and indicates 71.49. Which is correct? Thank you.

2019

f350

diesel

23/11/2019

Ford Thinus Du Plessis (160Pts.)

F-150 2019 std key and without keyless entry- Correct Installation guide

When I use the dropdown selection tabs on top to get the correct installation guide there is multiple options with no discription of the 2019 model. I need to know which installation guide to use for a 2019 F-150 std key and without keyless entry, truck. The product that was shipped to me is the EVO-Fort3 package

11/11/2019

Ford Curly Howard (130Pts.)

2019 Transit 150 evo-all fort1 harness will not recognize keys

Installed evo-all sn: 001a07052020 with fort1 harness without PATS. Attempted to program. Keys are not recognized. Attempted can programming only. Keys are not recognized. Remote start will not work.