Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

16/09/2024

Toyota Brum (130Pts.)

0

2019 Toyota Rav4 Push Start

Hello.  I am trying to program this myself after spending a lot of time and money over the years getting it reprogrammed as it seems to lose memory when major service is done.  I assume that is likely a Toyota issue that can't be helped.

I have about 6 to 8  hours in trying to make this work with little success but am concerned about all the wear and tear on the clips and wires from taking it in and out trying to get it to work so its time to ask for help.Perhaps verifying which manual is it that I should be using please and thanks.  The instructions seems simple but I am missing something.  I did just notice that all the instructions mentioned modules made after 2019 and over while mine is 2016 despite my Rav being a 2019.  Was it obsolete when installed or is that irrelevant?#001A06 654416The instructions that show up when trying to program this is Guide 83841 but i have been looking at many others trying to get it to work. thanks

0

2019 4Runner alarm going off during remote start

Installed the EVO-ONE/TOY-9/RFK441 into a 2019 standard key 4Runner. Not every start, but most starts are followed by the alarm going off. It's keeping the customer from using the starter out of anxiety. Any ideas? Did I program the EVO wrong? Did I program the RFK441 remotes wrong?

12/11/2021

Toyota G M (15380Pts.)

0

2019 lc150 turbo timer

Is it possible to implement a turbo timer for 2019 LC150? I want to install evo-all (stand alone) on it.

0

Guide 93711 2019 Toyota Rav4 Hybrid--is option D4 required (hybrid mode)?

Install guide doesn't mention enabling option D4 for Hybrid mode, although the guide is specific for Hybrid. Is this an oversight, or is it not required for this vehicle?

0

2019 RAV4: EVO-ONE + THAR-ONE-TOY12 Doors remain unlocked During Remote Start Session.

2019 RAV4: EVO-ONE + THAR-ONE-TOY12 harness setup; All the doors unlock then the vehicle starts fine but the doors remain unlocked during remote start session.

0

EVO-ALL-411 VS EVO-ONE-411

I WOULD LIKE TO KNOW THE EVO-ALL-411 VS EVO-ONE-411 COMPARISON   According to the site, the 2 are compatible on a TOYOTA COROLLA 2019 HACHBACK, PUSH TO START   Apart from the price what are the advantages / disadvantages between the 2 ???         J'AIMERAIS CONNAITRE LE COMPARATIF EVO-ALL-411 VS EVO-ONE-411   Selon le site, les 2 sont compatibles sur une TOYOTA COROLLA 2019 HACHBACK, PUSH TO START   A part le prix quels sont les avantages / inconvénient entre les 2 ???

 

0

Request: Pin or socket photos of THAR TOY-13

I'm installing an EVO-ALL into a 2019 Corolla Hatchback using a TOY-13 harness.  The harness is labeled TY70, and the connections to the factory ECU harness in the driver-side floorboard have different plug shapes.

If someone has a THAR TOY-13 and can take a photo of harness connectors that plug in between the blue and white/gray sockets, I would appreciate it.  Either the box I received was mislabeled, or Fortin's website is wrong.

(post as answer with photos or links to photo hosting site, please)

Thank you!

0

2019 RAV4: EVO-ONE + THAR-ONE-TOY12 INSTALLATION

Hi.

I'm using the following guide

evo-one_ig_rto_bi_toy12-rav4_2019_hkey_a_93691 

and following DCRYPTOR PROGRAMMING PROCEDURE my EVO-ONE doesn't respond for step 5 (Start the vehicle.   The BLUE LED will turn OFF.  The RED LED will turn ON.) it doesn't switch to Red.

Please assist.

Thank you.

 

GUIDE # 93691

REV.: 20200622

0

Request: Pin or socket photos of THAR TOY-13

I'm installing an EVO-ALL into a 2019 Corolla Hatchback using a TOY-13 harness.  The harness is labeled TY70, and the connections to the factory ECU harness in the driver-side floorboard have different plug shapes.

If someone has a THAR TOY-13 and can take a photo of harness connectors that plug in between the blue and white/gray sockets, I would appreciate it.  Either the box I received was mislabeled, or Fortin's website is wrong.

(post as answer with photos or links to photo hosting site, please)

Thank you!

11/04/2020

Toyota G M (15380Pts.)

0

2019 camry

For 2019 and 2020 Camry, is the instruction from 2018 Camry suitable?

0

EvoAll 2019 Toyota Rav 4 FWD Push to start not starting engine

EvoAll Regular installation without takeover. GUIDE # 83841 Programmed Flash-Link4 with latest firmware, and EvoAll updated to latest version as well. As a first time installer, I've installed this to the best of my abilities. Here are the EXACT steps that i took; 1- (-)start/stop TO EvoAll A19 2- (-)lock TO EvoAll A20 3- (-)unlock TO EvoAll A10 4- EvoAll B4 TO (+)12V ***I didnt, but must I install a 7.5 Amp fuse???*** 5- EvoAll B3 TO Ground 6- EvoAll A1 TO (+)Ignition ***I didn't but must I install a 1A Didode???*** 7- (-) Steering Lock TO EvoAll D6 8- (~)Can High TO C3 9- (~)Can Low TO C4 After programming the EvoAll, 3xLock will turn on the ignition, then turn off, and make a second attempt to turn on, then off again with no engine crank at all. AM I MISSING SOMETHING(S)???

0

EVO ONE ONLY RESPONDS TO OEM KEY FOB WHEN IGNITION IS ON (2019 4RUNNER)

2019 4Runner with T harness (Toy1 & Ty 30) . Double checked all wiring for correct location and proper connection. Everything on the installation side is good.

Problem...

I cannot use the 3x lock function as the Evo-One will not blink (blue led or anything else) with the key off. I can turn the ignition on and it blinks and responds to OEM fob lock/unlock. I can start the vehicle and press the lock button on the fob 3x and then turn the ignition off / remove key and the vehicle will stay running. I can also press the lock button 3x again and the truck will shut off with the fob..But then it will not respond anymore..

So the programming is correct, the wiring is correct, but for some reason on this 2019 4runner (standard key/t harness install), the door lock/unlock doesn't read when the ignition is off.

 

​The evo one is set up with monitor OEM option on

​Valet mode is verfied off and yellow loop is cut

 All programming of the immobilizer and canbus was successful, and I repeated the process again just to ensure everything was good.

​I have also tried various firmware versions and it is now back at the original/highest availible 


I can start the vehicle and press lock 3x and turn the ignition off and remove the key and the vehicle stays running, so everything is set up, but for some reason with the ignition turned off, the evo one doesnt register the lock/unlock commands on the keyfob.

 

I don't have the service number available right now, mounted the unit behind the dash and did not write the number on it down.

 

my guide for install is: Guide # 72361

0

Toyota Rav 2019

hello I have the EVO-ALL connect all the cables as the manual says I have the Smart Phone Module but it does not block my doors if I unlock it that is wrong in the module

0

19' Camry PTS - Trunk release and door open shutdown

Interior trunk button release button does not work but key fob release works. Evo all open door shutdown disabled but still shutdown when opening door.

0

19' Camry STD Key - door doesn't lock after remote start

Door does not lock after remote start. Function has been disabled through flashlink manager.

0

2019 Camry Std Key Hood Pin Wire?

Install guide says that it's mandatory to use the provided hood pin provided with the Evo One. Can't I just use the factory hood pin? If yes, where is the factory hood pin wire located?

0

19' Camry Std Key which wiring guide to follow for RM411 RF kit?

2019 Toyota Camry with Std Key. EVO-One with Fortin RM411. The wiring guides for both do not match. Which one do I follow?

0

2019 Camry Standard Key EVO ONE RF KIT

2019 CAMRY W/ STANDARD KEY. Once remote started, can the OEM remote lock/unlock the vehicle?

0

Oem remote functional while remote started?

2019 Camry w/pts. Once remote started, will the OEM remote still able to unlock/lock?

0

Has anyone successfully installed an EVO-One on a 2019 Toyota Tundra?

I installed an EVO-ONE on my 2019 Tundra Platinum and it worked for about 2 days and then lost all programming. I am pretty sure that the module failed and have a replacement on order but has any one been successful in installing one on the 2019 Tundra?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue