Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

16/09/2024

 Toyota Brum (130Pts.)

0

2019 Toyota Rav4 Push Start

Hello.  I am trying to program this myself after spending a lot of time and money over the years getting it reprogrammed as it seems to lose memory when major service is done.  I assume that is likely a Toyota issue that can't be helped.

I have about 6 to 8  hours in trying to make this work with little success but am concerned about all the wear and tear on the clips and wires from taking it in and out trying to get it to work so its time to ask for help.Perhaps verifying which manual is it that I should be using please and thanks.  The instructions seems simple but I am missing something.  I did just notice that all the instructions mentioned modules made after 2019 and over while mine is 2016 despite my Rav being a 2019.  Was it obsolete when installed or is that irrelevant?#001A06 654416The instructions that show up when trying to program this is Guide 83841 but i have been looking at many others trying to get it to work. thanks
Login to reply View 1 answer(s)

19/08/2024

 Toyota Tsengel Khishigsuren (200Pts.)

0

Toyota Prius V 2012 EVO-ALL 4 RED FLASHES

I installed an EVO-ALL on my 2012 Toyota Prius V (Hybrid, push to start) in standalone mode. When I try to remote start the car using the OEM LOCK-LOCK-LOCK sequence, the red LED on the EVO-ALL turns on, waits a few seconds, and then flashes four times. The car doesn't start, and the dashboard doesn't turn on either. Additionally, I've noticed that the security red light was flashing during the start sequence. The serial number is 001A07 076831. I've double-checked the wiring and FlashLink programming, and everything seems correct to me. Can someone help me?
Login to reply View 1 answer(s)

13/08/2024

 Toyota Michael Watkins2 (190Pts.)

0

23 tundra wire cut question

I have 23 tundra. do i realy have to cut the pink and splice the purple wires on 64 pin connector?? Is it so i can use oem remote while remote start is active and if thats the case can i just use the fortin add on remotes so i dont have to cut wires i dont mind having to have 2 key fobs if it means not having to cut factory wires ive had 2 key fobs since my first remote start years ago so it doesnt bother me. Thanks
Login to reply View 1 answer(s)

07/06/2024

 Toyota G M (14260Pts.)

0

windows toyota prius

Hello. Will Evo-All be able to lift the windows on a 2017 Toyota Prius?
Login to reply View 1 answer(s)

28/05/2024

 Toyota Joe Brown (160Pts.)

0

2020 Toyota Corolla sedan will no remote start

So basically I had it working for a couple years already and now I went to add a rf kit and it won’t remote start. I’ve reflashed, followed the instructions to a tea and had zero issues but won’t remote start. I try 3 times lock and the hazards just flash a 4th time and nothing happens
Login to reply View 1 answer(s)

22/05/2024

 Toyota G M (14260Pts.)

1

2014 4runner (key)

Hello. With evo-one, can I start a 2014 4Runner with an OEM key fob? 3x lock
Login to reply View 1 answer(s)

13/04/2024

 Toyota Christian Gomez (190Pts.)

0

MyCar will not start 2013 Toyota sienna! Tried everything!!

I have looked at all the question and answers with no luck. I update the firmware on the Evo-one, re-programmed every way possible with different firmware’s, re-programmed the mycar module, I’ve used with and without the little harness that comes with the mycar module, see if the Evo receives a lock/unlock signal while on (nothing), checked if the module is plugged in the right slot. I send the signal from the mycar app, turns green and then red for every option. The app shows signal, battery voltage, gps location, but it won’t accept any command. Please help!! (Can it be a defective device?) It worked before and all of a sudden stopped working.
Login to reply View 1 answer(s)

11/04/2024

 Toyota G M (14260Pts.)

0

2010 camry CAN wires

Hello. For a 2010 Camry (hybrid), where else can find CAN wires other than OBD?
Login to reply View 1 answer(s)

22/03/2024

 Toyota David Twardosz (130Pts.)

0

2023 Camry Push to Start

I have an Evo-All module flashed for a 2020 Camry, but have a 2023 Camry. I need a new wiring Harness. Would I need the Toy-16 harness. Also would the module being flashed for 2020 and not 2023 work? Thank you
Login to reply View 1 answer(s)

21/03/2024

 Toyota G M (14260Pts.)

1

2010 camry

Hello. I installed evo-all (3x lock...001A07582654) on a 2010 camry hybrid. After starting from the standard remote control, the remote control no longer responds unless we touch it on the car window. I installed the second module, but again the same.
Login to reply View 1 answer(s)

21/03/2024

 Toyota G M (14260Pts.)

0

2010 camry and evo-ride

After the failure of evo-all, I tried evo-ride... It was programmed (the LED blinked 10 times), but when connecting the mass on the blue wire (GVR), nothing happens... only the beep sound and nothing else - by pressing at this time on the start-stop button, nothing changes.
Login to reply View 0 answer(s)

03/02/2024

 Toyota G M (14260Pts.)

2

Avalon of miracle.

3 days ago one module did not work on 2013 Avalon. Today the 2015 Avalon arrived and neither that module nor the other module worked for this one either... Then CAN transferred the wires to a 30-wire connector and both modules started working (???). Maybe they have a standard autostart and it interferes or what?
Login to reply View 1 answer(s)

03/01/2024

 Toyota Jeremy Boliver (130Pts.)

0

2021 Tundra TPMS Not Working

Everything is currently working as it should. However, after tapping into the TMPS wire, now my TPMS flashes and the truck no longer reads the tire pressure. Is there a workaround for this, or is this normal?
Login to reply View 1 answer(s)

25/11/2023

 Toyota