Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

14/11/2019

 FAQ Robert T (300340Pts.)

6

FAQ: RED LED STUCK ON

When a module is stuck on the RED LED. 

    flash version 0.99 disconnect unit from the flasher and power cycle it in the car (connect/disconnect power connector) connect module back to the flash link and flash whatever firmware you need Turn settings protection OFF if it's on and SAVE the options. Reset the unit following the reset procedure. (this cannot be done while module is connected to the flash link) : https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193 Connect module back to the flash link and enable required options. Reprogram module to the vehicle following instructions in the installation guide.

 

Reasons this happened.

    Unit was connected WHILE doing the install. Unit was disconnected during CAN programming before the blue led started to flash. Power was disconnected while all other connectors were still connected.  during an update or save of options, the flash link lost connection to the module or the internet RF protocols not setup correctly, or RF device not paired to unit correctly. Datalink protocols not setup correctly. Bad ground. Loss of power during writing of data to the module.
Login to reply View 0 answer(s)

19/02/2020

 Nissan Hugo Zacarias (180Pts.)

0

Evo-all standalone module stuck on red light resets will not work

Remote start evo-all standalone install for 2017 Nissan Armada
Login to reply View 1 answer(s)

06/12/2015

 Kia eric desjardins (130Pts.)

0

Kia forte don't crank exterior lights flash

When pressing on the remote the exterior lights flash like the car would like to start but nothing happen. Constated that the 3 light of the fortin coupe dosen't light, except the yellow light of the ignition when key is on but engine off. The only information I got from the troubleshoot was the verify the power ground of the module, ground and 12v is there. All other options work fine on it. Saw three fuses under the dash and nothing blown. Need more infos the continue troubleshoot thanks. The module installed is fortin evo-all -Eric
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue