Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

10/11/2018

 Nissan khaled Salamah (130Pts.)

0

2009 Nissan Maxima PTS standard Installation With RS4-G5 No brake light!!!

Hi, all wiring is done propery Evo All progrmmed correctly, but the remote starter will not crank as the brake light will not go on.taking into consideration that the white red wire is connected properly to the 12+ brake switch wire (lightgreen on this vehicle). upon diognostics when the remote starter is engaged the white red wire should show 12+ to turn on the brake, but it dosn't so I jumped this wire to 12v during start only and the vehicle starts fine. I swapped three Evo ALL Modules to eleminate the deffective module assumpton and the problem stayed the same. Please Help As this is an Urgent Need. I have the flash link updater if and programming might help.
Login to reply View 1 answer(s)

25/02/2018

 Nissan Chuyen Ngo (220Pts.)

0

How to insert the prewired pins (Green and white wires) into the back of BCM connector (green), any certain way?

How to insert the prewired pins (Green and white wires) into the back of BCM connector (green), any certain way? Is there a special tool to use?
Login to reply View 1 answer(s)

16/01/2018

 Nissan Fahad Alotaibi (260Pts.)

0

worked finally evo all - NIST1 maxima 2014 normal EVO red led?

Hi I spent 12 hours to finish. I just want to confirm if everything is correct and won't have an issue in the future. A4 GREEN A5 WHITE A15 DOOR PIN A19 PTS Parking light The red led in the EVO and yellow turn on after I remote start. It says for 7 min then the red led goes off. Is this normal? Thanks
Login to reply View 1 answer(s)

10/01/2018

 Nissan MaDgamEr (180Pts.)

0

2014 Nissan Maxima defrost, heated seats and steering wheel

Do any fortin modules allow for heated steering, rear window defrost, windshield defrost and heated seat triggering when remote starting on 2014 Nissan Maxima? I see it is offered on some vehicles. Reason I ask is I believe it is canbus triggered on the Maxima, is it not?
Login to reply View 1 answer(s)

06/02/2017

 Nissan David Watson2 (130Pts.)

0

Lights stay on even when car is off!!!

Bought the Fortin Evo for the max...flashed it...everything works but when the car is off and locked, all interior lights including the outside factory courtesy lights stay on! Any suggestions?
Login to reply View 1 answer(s)

20/03/2016

 Nissan Bill W (1850Pts.)

1

Does Evo-One starter firmware .51 have all the improvements that firmware 1.18 brought?

Is firmware .51 the same as 1.18 aside from the "lock only at brake tap" option being available through RF kit programming? I know .51 was made after the 1.18 release but I am not sure that means .51 is a built off of 1.18. I am primarily concerned about the temp sensor setting that was updated to a higher temp in firmware 1.18. My defrost works reliably with 1.18 but does not with the lower temp setting of all the previous firmware versions. I need to retain this functionality if .51 is going to be my only "solution" to that head light problem.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue