Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

EVO All Activating 4wd in Rav4 2012

Problem 1 - The remote start sequence only works about 30% of the time Problem 2 - Sometimes when I turn my car on the 4wd function will be activated along with the ABS light on the dashboard. I can tell 4wd is in fact being activated but the weird part is that typically I would need to also lock my differential (that is the button you press to turn AWD on) but that light is not on and the mode will NOT be deactivated if I surpass 25MPH. Faulty device or common issue?

0

EVO-ONE Enables 4wd whenever I use the start command

Successfully installed the Evo-One in my 2005 Chevy Colorado. Prior to install did a master reset, updated to FW ver. 70.18 and then loaded the suggested settings in the Flash Link manager v4. Using the CRIMESTOPPER RFALL642W kit from Amazon for remotes. Whether it is a fresh start with an empty vehicle or a start command to put my truck in idle mode. Upon giving the command, the 2wd indicator turns off and 4wd goes on in the center console. Note: This vehicle uses pushbuttons to switch from one to the other. Not a clue what is going on here and any help is much appreciated. Thanks!

0

Evo-All on 2014 Nissan rogue causing check engine and 4WD error lights

It is a 2014 Nissan Rogue with the flip key. Installed using guide 75221 back in March of this year. Install was done by soldering. There was no issues during install, and no issues programming the module. I remote started the vehicle for 5 cycles before customer picked it up. No error lights. Customer called last week (8 months later) and said the check engine light came on, and the 4WD error light came on. They took it to the Nissan Dealership and they said the remote start is causing the issue because it was installed incorrectly. #1 I have done this exact install over a dozen times this past year and no one else has has an issue. #2 why would all of a sudden after 8 months it suddenly cause an issue? #3 is it possible there is a lag in the CAN Bus that is causing the error similar to some of the Chryslers where I need to change the firmware? #4 Why would this install be done 13 times on 14-18 Rogues and only this one have an issue?

0

Evo-All on 2014 Nissan rogue causing check engine and 4WD error lights

It is a 2014 Nissan Rogue with the flip key. Installed using guide 75221 back in March of this year. Install was done by soldering. There was no issues during install, and no issues programming the module. I remote started the vehicle for 5 cycles before customer picked it up. No error lights. Customer called last week (8 months later) and said the check engine light came on, and the 4WD error light came on. They took it to the Nissan Dealership and they said the remote start is causing the issue because it was installed incorrectly. #1 I have done this exact install over a dozen times this past year and no one else has has an issue. #2 why would all of a sudden after 8 months it suddenly cause an issue? #3 is it possible there is a lag in the CAN Bus that is causing the error similar to some of the Chryslers where I need to change the firmware? #4 Why would this install be done 13 times on 14-18 Rogues and only this one have an issue?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue