Utilisateur

Hello i m using standard installation with t harnesses, i cannot find a specific guide of evo-all + cm7000,

https://fortin.ca/download/87591/evo-all_ig_thr_bi_toy6-chr_2019_pts-hybrid_euro_a_87591.pdf

service number : 001A06753794

cm7000 has the connector nr.3 (Gray) with 6 pin, i connected the ground and the +12v in order to give power to the unit (i thought the voltage from the data port was enough, but it wasn't)

My question is on the pin nr. 5, guide says :

Pin 5 Green: Ignition 12V positive (+) output and input. This wire must be connected to the vehicles’
ignition for remote start and valet / remote programming. The proper wire will test 0V with the key in
the off position, 12 V (+) while the key is in the on position and 12V (+) during crank. Note: this is a
low current ignition output and will not support more than 1A (+)

 

Do i have to connect this wire to acc of my vehicle only for remote programming or it should be connected as permament? The evo all should give info of ACC ON to the cm7000 so this connection can be avoided right?

P.s I see the both cm 7000 and evo all are remote starter but i have to use the evo all as remote starter not the cm7000, so when i launch from the compustar remote the remote start routine how it works?

Hello,

I have the Evo-All installed in my 2011 Ford Fusion, an installation that has been in place since January of 2014.  I recently attempted to add the CRIMESTOPPER RFALL641W FM RF Add-on Kit and the Crimestopper Tele-connect smartphonne control.  I am able to program the Evo-All to "see" the RF kit (if the Tele-connect is disconnected), and I am able to program the Evo-All to "see" the Tele-connect as long as the RF antenna is disconnected.  But I am not able to get the unit to see both add-on devices at the same time.  I have flashed the unit as instructed.  If I have both connected at the same time, the RF kit works, but the Tele-connect does not.

Any ideas?  Your assistance is appreciated.