Recently tried to install EVO One in 2019 Atlas Push to Start. Latest Bypass Firmware Installed.
T-Harness VW6 & TB-VW Installed.
In the Instructions it mentions the CAN BUS is in the Steering Wheel Module Control.
This is a Non-Heated Steering Wheel and does not have the CAN Wires present in the OEM Connector. No Orange/Green or Orange/Brown Wires - Pins 3 and 4
Using WireColor - I have found and connected the Wires to the Driver Door Harness and confirmed the CAN Lines are correct.
Data CAN Bus (High) Orange / Green Steering lock module. 4 pin connector or driver door harness
Data CAN Bus (Low) Orange / Brown Steering lock module. 4 pin connector or driver door harness
During Programming - Step 1 - Released on Blue Light. Step 2 - Connected all Cables. Step 3 - Turn On Ignition. Step 4 - Press and release programming button once and wait for Rapid Flash of Blue Light and it never gets past this Step.
I have confirmed CAN Lines and Transponder Wires.
Just to also confirm - We cant use CAN BUS 2 from the OBD, Correct?
Any other Ideas of programming issue?
SN: 002B04 136811
Thanks
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
