Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

1

2005 Toyota Camry Starts but factory alarm gose off

Hello Everone We installed a EVO One Sin# 002B04690023 with 411 RF kit on this 05 Camry with installation guide # 84961 we folowed it to a T the vehicle starts fine but when the factory alarm sets it gose off with it running. Do we forget or need to set something in the evo one to disable or bypass the alarm we can't find any setings for this Please help. Thanks,

0

RFK912 on evo all works fine and starts, but after 24 hours, the remotes will not work until fobs are reprogrammed.

I have an evo all on my 2023 tacoma PTS. Installed the unit fine and works fine with factory fob. I installed the RFK912 kit to it followed programming directions and was able to successfully program my two remotes and those remotes work fine to remote start for about a day, then they stop working. factory remote starts the truck fine but RFK912 remotes no longer work. I have to reprogram the remotes to the evo all and they start working again for about a day, then they or the unit lose programming and I have to relink again. What am I doing wrong? Units were both brand new so Im thinking the batteries should be fine. Is there a step Im missing?

1

How can I have the EVO All RFK942 RF Kit maintain program for more than 24hrs?

2018 Toyota Rav 4 Push Start Ignition. Start X Remote Starter. EVO all RFK942 I programmed the RK Kit, but after 24hrs it drops the program. I have to keep programming the RF kit just to work again. maybe my sequence to program was not proper due to can’t find the best program instructions for a push start ignition. Please help. Thanks.

1

New registration of a RF-442 kit on an installed EVO-ONE with THAR-TOY8 kit

I have followed the intruction to the letter, but the problem i run into is that to set the remote programming mode, you have to press the antenna button 5 times, hit the brake, then use a programmed remote to click the lock button (mode 1)... but I don't have a programmed remote, because it's a new install. How am I supposed to use a programmed remote to enter remote program mode when I have brand new remotes that need programmed? I have the EVO-ONE programmed to use the antenna remote, and it is also flashed to use the OEM remote, which is working perfectly. I just want the extended range because the OEM range is NO bueno BAD. Vehicle is 2018 Toyota Corolla LE with H-key

1

New registration of a RF-442 kit on an installed EVO-ONE with THAR-TOY8 kit

I have followed the intruction to the letter, but the problem i run into is that to set the remote programming mode, you have to press the antenna button 5 times, hit the brake, then use a programmed remote to click the lock button (mode 1)... but I don't have a programmed remote, because it's a new install. How am I supposed to use a programmed remote to enter remote program mode when I have brand new remotes that need programmed? I have the EVO-ONE programmed to use the antenna remote, and it is also flashed to use the OEM remote, which is working perfectly. I just want the extended range because the OEM range is NO bueno BAD. Vehicle is 2018 Toyota Corolla LE with H-key

0

1-way RF kit with 2 4-button remotes very short range

RF kit 441 was programmed on Camry 2020. It was successful, but it is very short range, only 25 meters. What is the reason?

https://photos.app.goo.gl/JRRxv1NiZcJb6nNY9

0

1-way RF kit with 2 4-button remotes.

One All was installed well on camey 2020 , but the long range remote tried to program it and it was not programmed. Is it necessary to connect the cable in the attached picture

1-way RF kit with 2 4-button remotes.

https://photos.app.goo.gl/JRRxv1NiZcJb6nNY9

0

RFK442 not programming with Evo One for a 2009 RAV4 using HAR-ONE- TOY1 harness

I have programmed and installed an Evo-One using THAR-ONE- TOY1 harness in my 2009 Toyota RAV4, automatic transmission, standard key (dot key). Module S/N: 002B04211739, https://photos.app.goo.gl/gBSQdCrRweH1cRnC7   Bypass Firmware: 79.49, https://photos.app.goo.gl/PbEQgYMP1RPx6PgA8 Remote starter firmware: 1.25, https://photos.app.goo.gl/DkLyv2ttWCip77wS7   I have double checked the wiring connections, and seems everything is good.   Image 1: https://photos.app.goo.gl/uPvX8uTQnyqcuEyU9, Image 2: https://photos.app.goo.gl/TH6jQ8A2BPpa6H7P9 I can start the car remotely using the OEM keys. I would like to use the RFK442. I have tried to programming/pairing the RFK442, unfortunately I could not able to proceed after steps 3, page 2 in the following RFK442 programming manual.    https://fortin.ca/download/68451/rfk442-install-guide-68451.pdf The problem is: at step 3, the antena LED blinks once and then goes away (but the instruction says "The LED will turn ON").  At step 4, when I press the brake paddle 4 times, the antena LED doesn't response or no rapid flashing (instruction says "The LED will flash rapidly"). It seems like the RFK442 can not communicate with the Evo One.  I appreciate if you have any suggestion to overcome this issue and complete programming the RFK442 with the Evo One.  

0

RFK442 not programming with Evo One for a 2009 RAV4 using HAR-ONE- TOY1 harness

I have programmed and installed an Evo-One using THAR-ONE- TOY1 harness in my 2009 Toyota RAV4, automatic transmission, standard key (dot key). Module S/N: 002B04211739, https://photos.app.goo.gl/gBSQdCrRweH1cRnC7   Bypass Firmware: 79.49, https://photos.app.goo.gl/PbEQgYMP1RPx6PgA8 Remote starter firmware: 1.25, https://photos.app.goo.gl/DkLyv2ttWCip77wS7   I have double checked the wiring connections, and seems everything is good.   Image 1: https://photos.app.goo.gl/uPvX8uTQnyqcuEyU9, Image 2: https://photos.app.goo.gl/TH6jQ8A2BPpa6H7P9 I can start the car remotely using the OEM keys. I would like to use the RFK442. I have tried to programming/pairing the RFK442, unfortunately I could not able to proceed after steps 3, page 2 in the following RFK442 programming manual.    https://fortin.ca/download/68451/rfk442-install-guide-68451.pdf The problem is: at step 3, the antena LED blinks once and then goes away (but the instruction says "The LED will turn ON").  At step 4, when I press the brake paddle 4 times, the antena LED doesn't response or no rapid flashing (instruction says "The LED will flash rapidly"). It seems like the RFK442 can not communicate with the Evo One.  I appreciate if you have any suggestion to overcome this issue and complete programming the RFK442 with the Evo One.  

0

My test result feed back for Jesus

I tried reply Jesus at my last question, but it won't go through. so I started here.

Hi Jesus,

I did the one TPMS wire cut when car started with the key as you said. The "low fuel level warning light" came on as soon as I cut the wire.

Now it is clear In my case seems like the two TPMS wires is not connected inside EVO ONE when remote started the car,

So, what is next step?

 

0

RF KIT Comptibility.

How do I know which RF KIT is compatible with my Toyota Camry 2014 G-KEY. (EVO-ONE)

0

No horn chirp evo one 442 rf kit with a 2017 Tacoma H key ?

Everything works great on this evo one 442 kit, the rf remotes give an audible signal at lock, unlock, and start, and it works very well...but there is no audible horn chirp from the Tacoma at all, just the normal flashing parking lights , but no horn chirp. Is there a setting I'm missing on the bypass or remote side ?

0

12 Avalon PTS How does fob takeover work? RFK411 work?

I'd like to put an EVO-ONE in my '12 Toyota Avalon. If I install it with the RFK411 (I assume correct kit?) how does the take over from remote start fob to factory fob work? Does the car start then shut off when I open the door...then I restart to drive off? If that RF kit isn't correct which one do I need? Directions didn't seem to include PTS vehicles.

0

HOW TO CONNECT Compustar Prime G6 1 WITH EVO ONE IN 2007 CAMARY

HOW TO CONNECT Compustar Prime G6 1 WITH EVO -ONE AND PLZ SEND ME WIRING DIAGRAM

0

Does 2012 Toyota Avalon PTS use 3X lock or need RF kit?

I normally use a Crimestopper RS4-G5 with EVO-ALL but this Avalon has the intelligent key with PTS. Will it use 3X lock or will I need to buy an RF kit? Not really wanting to carry two fobs.

0

Does 2012 Toyota Avalon PTS use 3X lock or need RF kit?

I normally use a Crimestopper RS4-G5 with EVO-ALL but this Avalon has the intelligent key with PTS. Will it use 3X lock or will I need to buy an RF kit? Not really wanting to carry two fobs.

0

EVO one on 07 Tacoma and Fortin RF641W RF Remote Kit

I installed the rf remote according to the instrucions siclucing the t-harnes which is not applicable to my application. In the RF remote box there were instrucions on how to connect the antenna to the EVO- All but nothing about the EVO-one. The only place that the black 4-pin data connector for the antenna kit plugs into the same one as the flash link. Is this correct? 

When ateempting to follow the instrucions for programming i get to step 5 where you press the botton for the blue and red lights to come on. then when I inseret the keys nothing happens. the yellow light never comes on and the antenna never flashes. i have double checked the wires and nothing seems to be out of place?

0

Rf kit compustar t9 will work with evo one

Trying to connect the rf kit compustar t9 on evo one Wondering if is compatible and the remote start and alarm will work

0

Rf kit compustar t9 will work with evo one

Trying to connect the rf kit compustar t9 on evo one Wondering if is compatible and the remote start and alarm will work

0

Compustar pro g15, evo one and 2008 Toyota Corolla dot key

Wondering if the compustar pro g15 is compatible with the 2008 Toyota Corolla, using the evo one

1

Is the Compustar Pro T11 two-way RF Kit compatible with Evo-One

I have installed the T11 Rf Kit to an Evo-One on my 2014 Toyota Tundra and I am not recieving accurate 2-way communication between the remote and the Evo-One. Lock/Unlock/Remote Start functions operate correctly but it is essentially operating as a 1-way remote. I also recieve a false tilt alarm on the remote every time i lock my my vehicle usng the T11. No other 2-way communication exists between the T11 and the Evo-One.

1

Is the Compustar Pro T11 two-way RF Kit compatible with Evo-One

I have installed the T11 Rf Kit to an Evo-One on my 2014 Toyota Tundra and I am not recieving accurate 2-way communication between the remote and the Evo-One. Lock/Unlock/Remote Start functions operate correctly but it is essentially operating as a 1-way remote. I also recieve a false tilt alarm on the remote every time i lock my my vehicle usng the T11. No other 2-way communication exists between the T11 and the Evo-One.

1

Is the Compustar Pro T11 two-way RF Kit compatible with Evo-One

I have installed the T11 Rf Kit to an Evo-One on my 2014 Toyota Tundra and I am not recieving accurate 2-way communication between the remote and the Evo-One. Lock/Unlock/Remote Start functions operate correctly but it is essentially operating as a 1-way remote. I also recieve a false tilt alarm on the remote every time i lock my my vehicle usng the T11. No other 2-way communication exists between the T11 and the Evo-One.

0

do i need fuse protection from evo one in between connections for rf kit 642w re: 750 mA max output requirement

rf kit 642w wiring guide connectiong EVO ONE module to (-) lock/ (-) unlock wire requires 750mA max current does it need fuse protection in between connection corolla 2010 AT dot key w/ t-harness

1

rf kits can not program

i have installed an axone in a 2014 rav 4 my oem remote works with the 3x lock remote start nut i can not unlock the doors once the car has been remote started. i have tried to install an rf kit but can not get the remotes to program. the rf kit i have is fortin rf442w. can some one help me program my remotes?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer