I did the DYI Splice for the RF ant, I just spliced into the hot and ground wire of the WHITE pin connected to the other black 4 pin connector. The Blue light on the antennae comes on for a milli sec then goes out. I am unable to program the remote. I saw other post mentioning Turn on the RF from the REMOTE start side, but when I switch over I get a looking for device connection. what am I doing wrong?
Instead of going through the entire Q&A...please read this . Here's what I had to do.
1. To get the RF ANT and the EVO to communicate, i had to do more than splice a power and ground into the antenna....I had to splice the Red and Blue wire into the antenna too. That way it will communicate. as soon as I did this I was able to get confirmation that the RF Remote was getting pprogrammed. BUT it still didnt work.
2. I decided to look into resetting the EVO to default and reprogram ands in less than 15 min I was up and running. All remotes work and I'm loving it.
I appreciate Mathieu Bertrand Collin and Jesus Monroy for taking the time to point me in the right direction. I hope this Helps.
Karl
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
