English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

26/02/2022

 Toyota Haroon Shuja (190Pts.)

0

2020 Toyota 86 (PTS) starts for 2 seconds then turns off

I have an automatic 2020 Toyota 86 (PTS) with an EVO-ONE installed. From my knowledge, we have all the wires tapped properly. We ran into a few issues with the immobilizer wire but I believe we got that part sorted out. To confirm with the immobilizer wire, we cut the yellow immobilizer wire in half, tapped the light blue black and yellow red to the immobilizer wire that's connected to the ECU, and tapped the yellow green to the immobilizer wire that's connected to the other side of the car. Is this correct or should it be flipped? We're not able to aquire the immobilizer data for DCryptor but I think it's because it's not listed as supported on fortin's website, even though we go through the guide and finish with the Yellow and Red lights alternating on the EVO-ONE before attempting to use DCryptor. (Leaves us with a 'No data found' error). Finally, we installed the antenna for the RFK411 remote and programmed it. When starting the car, it starts for about 2 seconds then turns off. Does anybody know what could be causing this issue?
Connectez-vous pour répondre Voir 1 réponse(s)

29/08/2020

 Toyota ARUN Chandran (240Pts.)

0

2013 Toyota Venza takeover?

I have Evo All hardware version 6 latest firmware, when I open the door the vehicle shuts off, is takeover available?
Connectez-vous pour répondre Voir 1 réponse(s)

15/07/2020

 Subaru Chris cella (200Pts.)

0

My remote start shuts down after a few seconds if it is hot out and the AC is on

2015 Subaru Forester. My remote start shuts down after a few seconds if it is hot out and the AC is on when the car starts. Is there a way I can prevent the remote start from shutting down? I have no issue in the winter when I leave the heat on to warm the interior however, in the summer heat, if I leave the AC on, then remote start, the car shuts down after a few seconds. Is there a way to prevent this or troubleshoot the exact fault that is occuring?
Connectez-vous pour répondre Voir 1 réponse(s)

12/04/2020

 Toyota travis white (130Pts.)

0

2013 Toyota Tundra starts for a few seconds then shuts off

I have tried everything. I am pretty sure it's programmed correctly. It starts then shuts down seconds later. I am all out of ideas and ready to give up. Service number 002BO7 339682
Connectez-vous pour répondre Voir 1 réponse(s)

01/01/2020

 Subaru brian furr (170Pts.)

0

car starts then shuts down

I am installing an Evo one in a 2013 Subaru Outback with automatic transmission. The module was flashed with the correct software and programmed correctly and when I remote start it, it starts then shuts down. It tries a second time and then park lights flash 4 times The SN of my module is 002B04 051414
Connectez-vous pour répondre Voir 0 réponse(s)

03/03/2019

 Infiniti Josh Ley (500Pts.)

0

2009 Infiniti FX35 starts, shuts off after a minute or less

Crimestopper RS7-G4 with evo-all, firmware 72.37. has worked fine for several years. Had an issue several months ago that was resolved by updating firmware to 72.36 and reprogramming tach (would start and stall) Now, it’ll start, stay running, and shut down after a minute. Attempt to restart, run for a shorter amount of time, and same on third attempt. I changed firmware to 72.33, 72.34, 72.35, 72.36, 72.37 all with similar results. 72.32 (as recommended in guide 34361) Is this a faulty module? Or is there another possible solution
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer