Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

I purchased a single use token. It was never emailed to me

Hello, i purchased a single use token this morning and still have not received a email with the code? I would like to know how many days to expect before I receive the code?

0

Evo One not recognizing brake signal or key take over

I have an Evo One starts and stop from FTX64- 2W, tried it in two different vehicles same result. It's not recognizing key take over or 12v to black wire in 20pin connector to shut down. I read in a post, Derek mentioned wiring in a relay from the brakes that would send ground signal to the hood pin wire. Sounds like it will work. Will it have any adverse effect while driving, sending ground signal to the hood pin while driving if the key is not being recognized as being switched on?

0

Will not turn ignition on or start

I just installed the eco one in a 2017 Chevy trac key to start. It all installed great programmed fine and dcoded fine. It flashes blue when I hit the lock button and after the third time the red light comes on for a second then goes out.

0

2014 Chevrolet tahoe, after remote starting, engine stops running immediately when key inserted or brake pedal presed

Installed evo-all on 2014 Chevrolet Tahoe with t-harness and without data link. Firmware version 70.24. After remote starting vehicle then unlocking doors, entering the vehicle and closing doors the engine immediately stops running after brake pedal is pressed or key is inserted into ignition.

0

2013 EQUINOX WILL NOT START

2013 Equinox will not start. EVO-ALL. did the press 5 times programming, unplugged, went to the computer and finished programming. installed back into vehicle. blue light flashes 3 times by pressing lock 3x's, red light comes on steady, blue light briefly comes on. red light flashes roughly 10-12 times. red light stays on, then goes off. yellow light comes on steady and stays on. while all of this is going on the door chimes, door locks, and radio all come on as if the car was going to start. almost forgot to mention i did get the car to start one time. however, it never worked again. service number is 001A06835311. back of unit also says evo ford, evo mazda pre-loaded. is it possible that i was sent the wrong kit? box says equinox on it.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer