Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Evo One not recognizing brake signal or key take over

I have an Evo One starts and stop from FTX64- 2W, tried it in two different vehicles same result. It's not recognizing key take over or 12v to black wire in 20pin connector to shut down. I read in a post, Derek mentioned wiring in a relay from the brakes that would send ground signal to the hood pin wire. Sounds like it will work. Will it have any adverse effect while driving, sending ground signal to the hood pin while driving if the key is not being recognized as being switched on?

0

the evo does not detect the data

hi i have an evo one thats installed in a 2004 tahoe. followed guide 61101 and when trying to program the immobilizer bypass the blue light turns off and nothing else happens once the ignition is turned on. triple checked wiring and checked continuity. tried moving the wire to another leg of the bus distribution and that didnt work either. am i missing some software parameter or something ? SN:002B04 087218 tried software 70.18, 70.40 & 70.38

0

xtra wires? no red led when programming

2005 chevy silverado 1500 using install guide 61101 evo one. during programming blue led goes off but no red led, I have verified obdII connection. firmware is 70.21 another question is should i wire in the unlock, lock, +ign, -ign, -disarm on the 20pin?

1

2011 Silverado 1500 WT

Installed EVO-GMT4 and used provided T-harness for use as stand alone unit. Unit programmed according to steps in manual. Disconnected unit and updated to 70.18 using Flash Manager and FLU unit and and decrypted as well. All went well according to Flash Manager. Verified options C1 and D1 were enabled. Reconnected unit to vehicle and blue light flashes each time lock button is pressed, but vehicle never tries to start.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer