English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

25/12/2023

 Dodge Mark Day (130Pts.)

0

MODULE LED'S DON'T DO ANYTHING WHEN PLUGGED INTO VEHICLE

USED FLASHLINK, MODULE HAS CORRECT FIRMWARE, PLUGGED INTO VEHICLE CORRECTLY, HELD DOWN BUTTON AND ATTATCHED 4 PIN CONNECTOR TO MODULE, NOTHING HAPPENS. NO LED'S LIGHT UP AT ALL. evo-all standalone
Connectez-vous pour répondre Voir 1 réponse(s)

10/08/2019

 Volkswagen John Perry (130Pts.)

0

Cluster stopped working after install [EVO-ALL Standalone/Volkswagen Tiguan 2015]

I got everything installed and had it all working. Once I knew it was working, I disconnected the module so that I could clean up the wiring. When I got everything reconnected, I realized that the cluster had lost all power. Now I can't turn the car on using the key let along the FOB. I cannot figure out how this could happen so any tips or advice would be greatly appreciated.
Connectez-vous pour répondre Voir 1 réponse(s)

05/10/2018

 Toyota Greg Crowser (130Pts.)

0

No LED's when plugging in Data-Link wire

I'm using a Crimestopper RS7 with an EVO-ALL. Installation was working for a few weeks, then stopped. Now, when inserting the Data-Link connector while holding the button, no LED's light. When disconnected, the Crimestopper is putting out 12.0 Volts on the red wire, and 3.6 Volts on both the white and blue. After connecting to the EVO-ALL, the 12.0 Volts drops to 0.8. So I hooked up this EVO-ALL in a different vehicle with the same setup (Crimestopper RS7), The same voltage drop occured, with no LED's. In this different vechicle, I then replaced its original EVO-ALl, and everything worked again. So I assumed I had a bad EVO-ALL. Fast forward to today . . . I have a different EVO-ALL that I plugged in. But the same problem with no LED's. Any suggestions?
Connectez-vous pour répondre Voir 1 réponse(s)

27/12/2017

 Volkswagen Marquie Board (580Pts.)

1

VW Tiguan with T Harness gets no power when data link plugged in

Installing EVO all on 2014 Tiguan per guide #65501. When I go to plug in data link connector I get no power in order to try and program module. There are only 2 wires to connect, besides the harness connector itself, for the brake and ignition so Im not sure how to get power for the module? Any ideas.
Connectez-vous pour répondre Voir 1 réponse(s)

22/01/2017

 Chevrolet JR Grennell (130Pts.)

0

Why is there no power to evo with key off in a 2015 Silverado??

Kit says gmt1 under the gmt3 sticker. Do I have wrong kit? Cannot get any lights on unit unless key is in run position.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer