Car = 2022 Subaru WRX, Manual Transmission, Push-to-start
I have programmed, decrypted, and installed an EVO-One using the THAR-SUB4 Harness and an RFK3641 rf kit. When I try to enable the ready mode, the car is not remote starting. I have been following the procedure to activate:
Car is running, put in neutral, press foot brake, pull hand brake, release foot brake, here is where it gets weird. According to the instructions I should now press and hold the start button for 3 seconds, but before I get a chance to do that the car flashes the lights 3 times. When I press and hold the start button for 3 seconds nothing happens. I leave the car running, get out, the car automatically shuts off and locks the doors. When I go to remote start it, the lights flash 3 times and nothing happens.
I have tried doing this same thing with and without holding the start button for 3 seconds before exiting. I have also tried pushing the start button on the car before exiting (similar to "removing" the key), but the car immediately shuts off.
Looking for some assistance, thanks!
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
