I have a 2017 Mitsubishi Mirage Hatchback manual transmission with the standard key. I have an Evo-One installed according to the wiring diagram listed on this site. After a firmware update was performed on the bypass, I updated the firmware on the remote start portion of the unit. I then programmed it into the vehicle, went back to the computer and sent the information through to generate a key code. I reinstalled the unit in the car and when performing a remote start, nothing happens. The vehicle only reacts as if the car was not equipped with an additional device. I only hooked up the wires as shown in the install guide, nothing additional. Should I have hooked up others? Please help. Thanks.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
