I have a 2008 Infiniti EX35 PTS with the EVO-NIST1 and T-harness installed for a standalone remote start system. I used the most current firmware, turned on D1 and C1 options, and the module was successfully programmed. The vehicle will not start with the 3x lock signal, it will only go to on and then acc modes. In troubleshooting, I pressed the brake pedal and then tried the 3x lock which started the car. Further, I tried switching the RL1 to RL2 connector, but this did not work. Next I put a voltmeter on the white/red wire on the brake connector harness, during the startup sequence the voltage seemed to be constant but only 11 volts and occationally dropped to 0 during the sequence. I re-installed the firmware and reprogrammed the EVO again to make sure there wasn't any issues, but it still work work. Do I have a bad EVO, harness, or something else?
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
