2017 Forester X, key start, new EVO-One, installed per Guide #97491w/THAR-ONE-SUB1 t-harness, all connections made per pin location, not wire color. When I reach Step 5 on the DCryptor programming and start the car, I get red/blue on solid and they stay on even after the car is shut off, until I pull the 6-pin. Car starts normally with the key if the EVO-One is connected, will not start with the red plug disconnected, which I believe is correct. I've reset and reprogrammed the module twice with the same result.
Update after reading multiple other recommendations about getting to solid red and blue at step 5: 1. Instructions say to use Firmware 84.11 (minimum), I have 84.12 and .11 is not available. 2. I checked continuity from pin 10 (light blue) of the 20 pin connector (IMO signal) to pin D1 (Yellow/green) IMO body side and have continuity. Car starts and immediately quits with red "D" connector unplugged, starts and runs normally with it plugged in. 3. Have battery voltage at E1 (white) and E5 (pink) with ignition on, no power with ignition off. Module SN:002B04 656833.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
