I've got an EVO-ALL installed on a 2007 Dodge RAM with the Cummins Turbo Diesel engine as a stand alone starter. Green/Red starter wire was not present on the ignition cylinder plug, so I followed connection #1 on guide #8141, the only thing I noticed was the 12v wire was Grey/Red in this vehicle instead of Green/Red as listed in the guide.
Options C1, D1, D1.3, and D2 were activated using the Flashlink module.
Everything seems to work fine, but when the vehicle starts, the start signal is held even after the engine has started (around 1-2 seconds too long), causing the starter motor to grind. It eventually stops grinding and the engine stays running, indicating that the module is detecting a tach signal and should know when to stop cranking (at least I assume so).
I've tried both firware versions 4.18 and the recommended 74.17, with the same results though with 74.17 the door locks were a bit erratic when remote starting (they would unlock, then immediately lock before starting). I've also tried disabling option D1.3 and D2, with the same grinding happening.
The service # on my EVO-ALL is 001A06-338389.
Any help would be greatly appreciated!
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
