Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

10/04/2023

 Subaru jared halterman (160Pts.)

0

Car starts then immediately dies when I don’t use remote start

Remote start works fine but when I use the key to start like normal car dies immediately
Login to reply View 1 answer(s)

24/09/2022

 Subaru Timothy Mainusch (190Pts.)

1

2015 Subaru Legacy PTS starts and shuts down 2 seconds after, then it tries again and shuts down 2 seconds after

No T-harness. Programmed ok, Dcryptor ok. Updated after Dcryptor process. I have updated the module to current 84.12. I swapped the blue/black wire with the yellow green on the cut IMO. Still no start or LED.
Login to reply View 1 answer(s)

07/01/2018

 Subaru Jory S (520Pts.)

1

Shut off with OEM remote (after starting remotely)?

2016 Subaru Forester, Standard Key, OEM Remote, No Factory Alarm EVO ONE recently installed and everything works as expected using 3X lock with OEM remote. Is there a way to turn off the vehicle with the OEM remote after starting it remotely? I tried 3X lock after starting it but that didn't work. I didn't see any other options in the firmware. Is this only possible with an RF kit?
Login to reply View 1 answer(s)

07/01/2018

 Subaru Jory S (520Pts.)

0

EVO ONE alarm with OEM remote?

2016 Subaru Forester, Standard Key, OEM Remote, No Factory Alarm

EVO ONE recently installed and everything works as expected using 3X lock with OEM remote.  Is it possible to take advantage of the built-in EVO ONE alarm while still using the OEM remote?  With option 9.1 & 14.2 enabled, the alarm is armed when the doors are locked, but I can't figure out how to disarm the alarm on unlock with the OEM remote (instead, the alarm is triggered when unlocking with OEM remote and opening door).  Is this possible with the OEM remote or only with an RF kit?

Login to reply View 1 answer(s)

05/10/2017

 Subaru Jeremy Jedlicka (180Pts.)

0

EVO-ONE + THAR-ONE-SUB1 for 2018 CrossTrek

I just purchased a 2018 CrossTrek Premium regular key with EyeSight. Just want to verify that the EVO-ONE with the THAR-ONE-SUB1 T Harness is compatible with the new model year and the 2017 wiring information from this website will work.
Login to reply View 1 answer(s)

06/02/2017

 Subaru Heath Ekin (130Pts.)

0

Oem key fobs dont work now, need help. 2016 impreza evo one

I've triple checked the wiring. Done the programming dcryption, master resets, and firmware updates. Enabled 38.2 c1 and d5. The car will start with key but no remote access.
Login to reply View 1 answer(s)

06/12/2016

 Subaru felipe sesnich (160Pts.)

0

2015 crosstrek program OEM RF transmitter lo enable 3x start.

 

2015 CROOSTREK WONT REMOTE START. HOW DO I PROGRAM OEM RF TRANSMITTERS TO REMOTLY START VEHICLE.

I FOUND THIS TROUBLESHOTING THE EVO-ONE. 

DECRYPTOR DONE AND UPDATED , INSTALLED BACK TO CAR BUT DOESNT REMOTE START WITH 3X LOCK)

If the red led is not turning on then the module is not receiving a start command. Verify that the RF kit being used was properly programmed.

If it does turn on briefly then shut off right away, pay attention to the parking light flashes. 

Login to reply View 2 answer(s)

06/12/2016

 Subaru felipe sesnich (160Pts.)

0

2015 crosstrek program OEM RF transmitter lo enable 3x start.

 

2015 CROOSTREK WONT REMOTE START. HOW DO I PROGRAM OEM RF TRANSMITTERS TO REMOTLY START VEHICLE.

I FOUND THIS TROUBLESHOTING THE EVO-ONE. 

DECRYPTOR DONE AND UPDATED , INSTALLED BACK TO CAR BUT DOESNT REMOTE START WITH 3X LOCK)

If the red led is not turning on then the module is not receiving a start command. Verify that the RF kit being used was properly programmed.

If it does turn on briefly then shut off right away, pay attention to the parking light flashes. 

Login to reply View 2 answer(s)

30/01/2016

 Subaru shemis.pro Alex (200Pts.)

0

EVO-ONE wont start with oem remote with factory alarm.

Service no 002B05 027677

 

Hello.  I`m trying to take a work EVO-ONE for subaru outback 2011, automatic transmision, with  factory alarm. so loop is cuted. i used GUIDE # 46701 for harness conection. turning on ignition yelow light goes on. when i pushing lock button 3 times nothing going at all (blue light- no, red light - no). is there problem in incorrect flashing?

 

Service No: 002B05 027677 Preload date: 47-2015 Hardware version: 5 Firmware version: 1.17 Recommended version: 1.16    

 

Login to reply View 2 answer(s)

30/01/2016

 Subaru shemis.pro Alex (200Pts.)

0

EVO-ONE wont start with oem remote with factory alarm.

Service no 002B05 027677

 

Hello.  I`m trying to take a work EVO-ONE for subaru outback 2011, automatic transmision, with  factory alarm. so loop is cuted. i used GUIDE # 46701 for harness conection. turning on ignition yelow light goes on. when i pushing lock button 3 times nothing going at all (blue light- no, red light - no). is there problem in incorrect flashing?

 

Service No: 002B05 027677 Preload date: 47-2015 Hardware version: 5 Firmware version: 1.17 Recommended version: 1.16    

 

Login to reply View 2 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue