I have installed all the wiring according to Guide #19101. The module appears to successfully have programmed to the car, however, when I do the 3 button push on the factory remote it does not start the car. I have attached the rf642 and was able to successfullly program one of the remotes. When I try to start the car via the 2 way remote, the parking lights come on and it it looks like it is trying to start, however, none of the dash lights come on. The red led by the cut loop wire is blinking and after about 30 seconds it quits attempting to start. I can also hear sounds in the car as if something was activated, When it finally quits, the partking lights appear to blink 4 times, which should indicate no tach. But Im not sure what to look for in that.
And finally, the 2 way remote was controlling the locks at one point, but that has stopped and I am not able to program the second remove via the valet switch or by the ign on off on method.
Edit: I have been able to get the other remote to program and now the remotes are making calls to the bypass/RS, however, when I try to RS the car it clicks, RED LED comes on, but it does not go ignition. After it fails twice, the lights blink 4 times still. Not sure why it wouldnt be getting tach at this point.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Buick
Cadillac
Chevrolet
Ford
GMC
Hyundai
Kia
Mazda
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
