Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

20/12/2022

 Audi Vincc (230Pts.)

0

Can't complete Step 5 - Blue LED don't Flash. Audi S4 2014

Anyone can help me? I'm Stuck on Step 5 while programming my EVO-ALL with the T-Harness EVO-AUDT1 on My Audi S4 B8 (2014). The BLUE LED doesn't begin flashing. CAN Connections are Good. I Measure round about 3V on the Whit 5 Pin connector between Grey and Grey-Black. Grey-Black goes to Orange-Brown (CAN-Low) and Grey goes to Orange-Green (CAN-High) like in the Guide described. I have connected these Cables at the CAN Connector near the Relays at the left bottom under the Driver footwell. S/N: 001A06905491 Thanks!
Login to reply View 1 answer(s)

22/03/2022

 Volkswagen Willem Den Besten (240Pts.)

0

Blue light won't flash in step 5 in guide 65321

Hi On my 2012 vw jetta manual transmission push to start. I connected everything it told me to connect on the wiring diagram but when I turn the ignition on the blue light turns of but won't flash Please help
Login to reply View 1 answer(s)

09/02/2021

 Ram Russell Hultquist (130Pts.)

0

Blue light never comes on

I get to step five re-insert the key in the red light stays on the blue never comes on at all. I have a 2017 Ram 1500 key start.
Login to reply View 1 answer(s)

23/10/2020

 Ram Karrim Jackson (130Pts.)

0

2020 Ram 1500 Push To Start, Blue light does not flash on step 5

While on step 5 the blue light does not flash. Once the button on the eval all is pressed the solid blue light goues out but the blue light does not flash as indicated in step 5. The unit has been flashed to latest firmware 63.01. Wires are connected per the chart.
Login to reply View 1 answer(s)

30/05/2019

 Ram Jim Forster (180Pts.)

0

2015 RAM 1500 Push to start never gets to step 5 (Stays solid yellow)

I have completed a master reset, and programming just the CAN-BUS works properly. When pressing the ignition button (push to start) the unit never goes red. (The documentation that came with mine shows a keyed unit, so I'm going by another guide I found saying to hold the fob up to the push-to-start button and push it twice.) I have reprogrammed the unit a number of different ways (including everything off but the two 'recommended') and still no luck. Right now I have A3 A7 D6 as the only ones enabled and it still just stays yellow. Thanks!
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue