Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

A/C don’t work cool

when I start the engine by lock lock lock the air conditioning does not work only work the blower but not cold if I push the start stop bottom yes work fine is a 2019 Nissan Titan sv rwd 5.6L gasoline

0

Démarreur à distance

Comment faire pour ne pas devoir redémarrer lorsque j'embraye mon véhicule suite à l'utilisation de mon démarreur à distance. Merci !

0

2020 Durango A/C automatically comes on

Installed the EVO-ALL today and the remote start is working (Now that I hit LOCK 3 times instead of the suggested LOCK/UNLOCK/LOCK sequence). My problem is it automatically defaults to A/C (or LO) on my automatic climate control. That doesn't help when it is 20 degrees out here. My temp setting when I leave the vehicle is 74 degrees. I do not have heated seats. Any suggestions?

0

Honda Civic 2008 manual transmission I want to install an Evo one de do you recommend thanks

Tengo una transmisión manual Honda Civic 2008 Quiero instalar una Evo que guía de instalación me recomiendan gracias

0

Jeep Grand Cherokee 2001 tachometer signal

Hello, I am using an Evo-All version 7 system on a 2001 Jeep Grand Cherokee, normally the firmware used should be 4.06, this is only available on version 6, so I use 74.22, everything works perfectly well except the tachometer signal which is not suitable, when I use my remote start the engine starts well then shuts off after a few seconds (the skim works well the problem does not come from the)   I know that some people will tell me to buy a version 6 in order to put firmware 4.06 in it but I live in France and it is very difficult to find the Fortin brand here, and therefore even more difficult to have a choice on the hardware versions ...       Do you have a solution? Is the signal present and not strong enough? (I ordered a digital oscilloscope to check this) Would it be possible to get an update worthy of the name for the J1850 protocol and the Evo-All version 7?       Hoping to have a solution ...

0

How can I get the lights back to working in the rear hatch on a 2008 GMC Acadia

What color is the power supply and ground coming into the rear hatch and loaction of a 2008 GMC Acadia and is there a fuse somewhere going to this power supply? I was trying to see if I could get the tag type back up camera to work on this vehicle and there was a red wire coming out of the camera wire not hooked to nothing that got aganist the groung and that is when it went dead along with the lights in the hatch. The other part of the red wire still has power when you put vehicle in reverse. but the red wire hanging loose and the lights in the rear hatch has no power at all, I have checked every fuse in the car and especially the camera fuse and they are all good even tho it seems like I blew a fuse when the loose red wire sparked aganist the ground while I was moving wire around. At this point if I could get the lights back to working correctly in the rear hatch I could do without the camera. Pleas help Eddie Cansler

0

Rf kit for evo one

0

quesque le data link

je regarde pour installer le evo-all avec thar-maz1 sauf dans les document d'installation je voie qu'il parle du data-link. quesque ses exactement le data link esce un module suplementaire qui reste permanent avec le evo one ?? et si je L,install pas esce qu'il faux les fils en pointillé doit etre connecter? et de plus le fils jaune qui doit etre brancher a l'ignition ses quel fils exactement qui doit aller pour un mazda cx5 2014?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue