Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

evo all with rfk411 starts 2014 wrangler but immediately shuts off

i have the evo all, updated firmware, corrected the setytings in the flashlink to use H2 for the rfk411,what els eshould be enabled? the jeep starts, runs for 2 seconds and then iss witched off again by the evo all. then the evo has the red and orange light solid.

0

Where is the Tach wire on the EVO-ONE

2014 Wrangler manual transmission I have no remotes for this unit and plan on using the OEM remote. The unit will not remote start. The flash tool says that the tach wire needs to be hooked up, not to use the tachless mode. So, Which wire is it? I will need the PIN number too since the extra wires have been removed to reduce the wires in the install.

0

2014 jeep compass wont start push button 3x

will lock and unlock but wont start.

0

2014 Jeep Patriot Purpose of hood pin/valet, parking light, start/stop external connections

I am looking to Connect a Evo-All Stand Alone on a 2014 Jeep Patriot. I am following installation diagram C. When I bought this evo, it was preflashed and listed as only needing to connect the harnesses. I have not attempted any installation yet. For the single wire connection coming off the 20 pin connector, I am looking for more infomation on the purpose of them to determine what is necessary and to allow me to locate the wires and troubleshoot any incorrect connections. -For the 20 Pin Connector i. Externial input (Start/Stop External control negative) - What is this and what would this connect to? ii. Parking light out negative (this is the white/purple positive for 2014 jeep patriot) - Is this just to blink the break lights and would a relay be required to make this connection, if so is this connection necessary. If it is necessary would it connect to the red/purple wire (shown on wirecolor.com under parking lights) iii. Hood pin/Valet switch (no valet switch for 2014 Jeep Patriot which is a hatchback) is this a necessary connection and if so, where would this connect to near stearing column (without running under hood to actual switch). The directions state that this is optional, dark blue (from 20 pin connector) with no polarity given. Wirecolor.com list this as negative black/pink (from the 20 pin connector), and has no location or pictures of the colors. Yellow and Green/orange will be connected per instruction C. Seller Flashed for Stand Alone T Harness Hardware V6 Firmware Vr 74-19 (Seller may have updated it further) Date 11/2015

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue