Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

everything was working now its not starting

i just installed an evo one on 2012 nissan versa standard key.im using nis5 t harness with rf442. i installed all the wire except the door lock/unlock vehcile was remote starting with delay the ignition instrument panel lights turn on and click turn off start second time it would start .i removed the evo ground and now when i try to start i see red light flash and hear clicking from evo one with no sucessfull start please help.lock un lock wires are still not connected. im not using door pin and hood pin wire which are grounded to chasis.

1

2013 Nissan Versa Standard Key No Transponder Evo-One

I believe my issue might be similar to this question: https://fortin.ca/en/qa/93425/2016-versa-note-std-key-no-transponder-unable-to-program-evo-one?show=93425#q93425

This Versa does not have a transponder so I am getting stuck on the same step. The other question mentions a method of programming using the blue led. I am unable to find these steps. Are there steps listed somewhere to progam a nissan that does not have a transponder?

0

Where is another location for the transponder connector wires?

2016 vera note standard key. I dont have the transponder connector in the location it says. Has one thick black cable in that location. Is there another spot to get the rx and tx wires? Thanks.

0

Bypass doesn't work when remote starting car. Nissan Versa 07 + evo all

Alright, so heres the deal. Compustar 4200 (i think) and evo-all on nissan versa 2007 So I got a little bit lazy and i think its why, will wire up everything next day or two as its late and I have a truck to work on. remote starter everything is wired in except for trunk unlock (was gonna do it after) evo all - all things wired except door pin (figured the autolight shutdown wont affect much) wired via datalink looking over the guide again - i missed the arm/disarm to remote starter (not sure if its needed as lock and unlock works) I haven't updated the evo all but it says hardware version 6 firmware 4.18 - so it passes minimum spec programming worked like a charm, several times Either way - try to remote start, and no go, key works fine most of the time (trying the key directly after remote start fail wont work either but giving it a few seconds makes it fine)

1

i check voltage and Can- lo reads about 2.5 but I dont get a reading from Can Hi

Rookie installing EVO ALL on 2012 nissan versa. I followed the steps through programing and the EVO all blue light does not come on during step 4. I check voltage on Can HI and i am not getting a reading. I checked some of the fuses and they are all right.... How do I go about to fix this problem?

23/03/2014

Nissan (Pts.)

1

evo does not detect can bus. what next?

Rookie installing EVO ALL and remote starter/ alarm on a 2012 nissan versa. While programing the imobilizer i only got to step 4 (the blue light never comes on) Trouble shooting says that the imobilizer does not detect the can- bus. What is the next step?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue