Utilisateur

Hi,

I am planning to install Smart Entry and Push start system from Advancedkeys.com for 2013 Toyota Camry

I currently installed Fortin Evo one in this car.

Smart entry, push start system from advancedkeys.com states that they support Fortin for immbolizr bypass.

Please refer https://advancedkeys.com/Prod_AK105B.html in that scroll to bottom of the page and look for bypass device enable output..

Question. 

1) After market push start system (AK105B) can output negative ground out while running, can I can take this ground out from this module and activate my fortin evo one for immobilizer bypass.

2) Just incase if you want to know the Manual of after market push start system. Please refer to https://advancedkeys.com/Prod_AK105B.html and in that look for details/manuals section click that tab and scroww down to download AK-105 Smart Key Installation Guide. 

3) Do you guys plan to sell something similar in future or is this in your pipeline.

4) Please note this unit is capable of doing remote start but i am planning to use fortin evo one for remote start and strictly using other one for push to strat and smart entry.

Thanks in advance.

This is 2013 Toyota Camry G Key. Bypass Version 79.37 and Remote Starter version 1.19.

Bypass version a1 to a11 is on. Rest all are off.

When i try to start the car using Remote, Vehicle crank but wont start. Parking light flashes 4 times. This means Tach signal is not obtained properly from Can bus. 

I see sometimes, car Starts and since Tach signal is not obtained properly the starter disengages slowly.

Sometimes it crank and it wont start.  Please advise how to solve the problem. I am using fortin RF642W

remote and the remote are configured with no issues.

I have verified Can high, Can Low and IMMO data from where i tapped to the wiring harness of EVo one, i see good continuity. 

Issue 2: My OEM remote is not working. I enabled 3 times lock on remote and bypass but still not working. Not a major issue. but dont know why it is not working. PLEASE NOTE i have enabled 3xlock on remote start and oem remote monitoring on bypass, but still it doesnt work.

Issue 3: After i remote start the car(when it work sometime) if i open the door(getting my hand inside the door and opening the door from inside), there is no alarm. I am thinking that if i lock the car with remote, and when car is remote started, then if i try to open from inside of the car, i expect car alarm to come on but notihing happend. Issue 2 and 3 are not high priority. but for sure issue 1 have to be addressed. I am happy to wire tach (hard wire). but dont know what to connect from where.. 

i have cross verified my 

here is my option for remote starter version 1.19.

39.1