Does the current firmware for the EVO-ALL read the CAN-BUS for door status on a 2008 Jeep Commander Sport? I currently own the EVO-ALL with THAR-CHAR4 for my Commander. The EVO-ALL is currently configured and function nicely. All options work (ex. remote start, alarm, parking lights, horn/siren). The Commander has no factory alarm. If I arm the EVO-ALL I can open ANY door and the siren will not sound. My wait time is 60secs. I know the alarm is armed because if I attempt to turn over the ignition the alarm sounds and the key sentry flashes as expected. Another question is have you actually had a chance to test the CAN BUS High and Low on this vehicle? I personally don't think the current firmware is allowing the EVO-ALL to detect the doors on the network. In relations to the alarm and doors I have played with Option G4. The option works on firmware ver. 7.34 but not on 7.22. However 7.22 is the only version that allows the alarm to work!
P.S. I also purchased an EVO-ONE. Do you think the EVO-ONE would do a better job of detecting the doors on the CAN BUS?
OPTIONS ACTIVATED:
C1, D1, G
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
