Utilisateur

I am looking at Guide #  93381 for Honda Fit/HRV and it does NOT show the two relays or diodes of the THAR-ONE-HON8 harness.

Other car which using the same harness--TLX, ILX, RDX, RLX, Odyssey--, their guides #99801, #93631, #93591, #93601, #97191 are showing in diagram 2 relays, 2 diodes, and 7 cuts.

Is there a better guide for Fit/HRV showing where these two relays connected?

What is their function , what are they switching ON / OFF ?

Are there 2 diodes hiding inside the wire harness ?

Thank You !

please reset my EVO-ONE flash limit to 0

Service # 002B07296028

Thank You!

2019 Honda HRV      Automatic    Push to Start      EVO-ONE   THAR-ONE-HON8    OEM remote 3X start

During setup with Flashlink, in System Setup, this selection shows:

Please select vehicle setup: Remote Start    -Remote Start & Alarm-    Alarm Only

I have selected Remote Start, and  I am using OEM remote with 3X remote start.

I can unlock the car with OEM remote UNLOCK and engine stays on.

However, if I  to use the outside push button on the door handle,  and open door,..engine shuts down !

Maybe I need to select Remote Start with Alarm option during setup ?

I am following steps in Guide #68261.

1) As per large yellow "ATTENTION" warning, disconnected - terminal from battery.

2) Removed covers

3) Made the following connections: #4,#5,#6

7) Made the other required connections: Diagram on page 4 (Connect everything else)

6) Reconnect - battery terminal

Page 7 Step 1: Connect the 6-pin Main Harness

--already connected everything to Evo-One control at #7, however diagram show Evo-One control with NOTHING connected !

Are those connectors magically disconnected by themselves ? Maybe  missing instructions ? 

....disconnect battery - terminal ?   .....disconnect all connections from Evo_One control ? ...reconnect - battery terminal ?