I used guide 17323 revision 20140804 to wire up a 2015 Hyundai Genesis PTS to and EVO-One. I have programmed the EVO-One and it responds as the directions say. I have oem remote monitoring on, when I lock the doors three times, I get a blue blink every time I hit the lock button, on the third press the parking lights come on, the doors unlock, the car's dash screen comes on but it doesn't start. The middle LED on the EVO-One is lit orange and after about 5 seconds it locks and unlocks the doors, then about 5 seconds later it locks all the doors and the middle LED shuts off. If I had to guess I would say that the starter out is either not sending the signal or the starter+ is not hooked up correctly? I have it hooked to the brown orange wire in the loom indicated on the wiring diagram but there are a ton of wires there. What else can I do to troubleshoot? I am running firmware 76.16 with C1, D1, D1.6, D2 and D6 turned on
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
