EVO-ONE with T-Harness installation
For the tachometer setting when I select Tach Data-Link only (20.6) or Tachless on crank and supervision by Tach Data-Link (20.1), the car shuts off after 2-3 seconds after the engine starts. However, when I set Tachless only (20.2) the engine stays on. Is it okay with selecting Tachless only setting? I thought it's better for evo to continue monitoring the tachometer.
With the Tachless only setting, I started the car with OEM remote X3 Lock feature. When I pressed UNLOCK (with the original key for programming the module) to get in the car it wouldn't open the door. I already made some connections with Yello/green(D1) and yellow/red(D3) to make my oem remote to be operable when engine is running. Is there anything i can do to diagnose this? I did the continuity test on the wires and it was fine.
When I set down on the car and stepped on the brake pedal, it didn't shut off the engine although I enabled the feature through the flash link. Do I need to wire something extra? I know where is the foot-brake line in the car, I just don't know where I can connect it to on EVO-One.
And when i tried to start the car with my key, it wouldn't start the engine. Now i can only start the car with my remote.
Any solutions?
Thanks
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
