I am in the process of installing an EVO-ALL device with a Fort3 cable into a 2016 F150 XLT with standard key.
The module programmed correctly.
The hood is definitely closed.
When attempting to remote start using a LOCK, UNLOCK, LOCK sequence the BLUE LED flashes once with each LOCK button press and twice with the UNLOCK button press.
After the third (LOCK) button press the LEDs go through a flashing sequence that ends with a pause (no LEDs lit) followed by three quick flashes of the RED LED which I understand means NO TACH.
I verified that options C1 and D1 have been turned ON by doing the following:
I grounded the A8 pin of the 20 pin connector. The RED LED did NOT light so option D1 should be on.
I momentarily grounded the A13 pin of the 20 pin connector. The LEDs went through a flashing sequence very similar if not identical to the one that they go through when attempting a LOCK, UNLOCK, LOCK type remote start. The flashing sequence ended with the same pause (no LEDs lit) followed by three flashes of the RED LED which I understand means NO TACH.
Any ideas?
Thanks!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
