Hey,
Installed EVO-ALL with separate remote starter using t harness. All commands/triggers work as expected from the remotes, including remote start (and key takeover when remote started).
If started normally using the key port, the car starts, but key is not sensed in the port so once a door is opened/closed, reservation mode will set with the key still in the port, then shutdown the engine.
I'm using the CM7000 - should I splice the Key Sense INPUT (of the CM7000) to the "Key In" (EVO-pin A20)? I thought this would have been communicated over data, but maybe not.
Any other ideas, or suggestions?
Car: 2011 S4 Manual Trans. Keyport
Service #: 001A06901001
Thanks.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
